We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee press fitting, 2-1/2 by 2 by 2-1/2 inches, 200 psi

Viega

Viega 20714 ProPress XL reducing tee copper 200 psi

SKU CH-VDDG-HSPSN

Copper reducing tee connects 2-1/2, 2 and 2-1/2 inch tubes with press-fit ends rated to 200 psi

  • Reducing tee joins 2-1/2" and 2" copper lines in one fitting
  • Press-fit connections install fast without soldering or threading
  • EPDM O-ring seals potable water systems to 200 psi
  • Copper construction resists corrosion for long service life
  • Centre-stop dimple ensures correct tube insertion depth every time

ProPress XL reducing tee

The Viega 20714 is a copper press-fit reducing tee designed for potable water systems. It connects a 2-1/2 inch run to a 2 inch branch without soldering or threading. Professional plumbers and mechanical contractors use it for commercial and residential distribution lines. The fitting carries a 200 psi maximum operating pressure rating.

Sustained pressure performance

The copper body and EPDM O-rings maintain a seal at the full 200 psi rating over long service periods. Press joints resist vibration and thermal cycling without loosening like threaded connections can. The centre stop dimple ensures consistent insertion depth on every joint. No flame or flux is required during installation.

Build quality and daily use

The one-piece copper construction eliminates potential leak paths from brazed joints. Press-fit ends accept standard ProPress XL jaws for fast, repeatable connections. The reducing configuration simplifies pipe routing by avoiding separate reducer fittings. Overall length is 7 17/32 in, allowing compact layouts in mechanical rooms.

Highlights

  • Reducing tee joins 2-1/2" and 2" copper lines in one fitting
  • Press-fit connections install fast without soldering or threading
  • EPDM O-ring seals potable water systems to 200 psi
  • Copper construction resists corrosion for long service life
  • Centre-stop dimple ensures correct tube insertion depth every time

Specifications

BrandVIEGA

Questions about this item

Does the Viega 20714 ProPress XL reducing tee generate any noise or heat when pressurised to 200 psi all day?

The copper fitting has no moving parts and creates no noise or heat under continuous 200 psi service.

What press tool and jaw set must I already own to install the 2-1/2" and 2" press-fit ends?

A compatible ProPress XL press tool with 2-1/2" and 2" jaw sets is required for the three press-fit connections.

Will the EPDM O-rings on this reducing tee seal reliably against older copper pipe that has been in service for years?

The factory-fitted EPDM O-rings are designed to seal on clean, round copper tube of the stated sizes regardless of pipe age.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.