Victron Energy
Victron Energy Orion-Tr 24/24V 12A 280W IP43 Isolated 2 in 1 accessory
Isolated DC-to-DC converter steps 24 V to 24 V at 12 A with 280 W output and IP43 splash protection
- Stable 24 V output protects sensitive gear
- High-efficiency design reduces energy loss and heat
- IP43 splash resistance suits damp environments when fitted correctly
- Screw terminals enable tool-free wiring
- Isolated 280 W unit handles 12 A for dual-battery systems
Victron Orion-Tr 24/24V 280W converter
The Victron Energy Orion-Tr is a new isolated DC-to-DC converter that steps 24 V input to a stable 24 V output at 12 A for 280 W. It is built for dual-battery systems that need galvanic isolation between the source and the load. Screw terminals make wiring straightforward without special tools.
Suits vehicles and boats needing clean isolated
Installers who want a compact unit with IP43 splash protection for occasional moisture will find it a good fit. It is not intended for AC mains input or for systems that require a different output voltage than the 24 V this model provides. Buyers needing higher current or a non-isolated design should look at other configurations in the range.
Delivers 280 W continuous with IP43 headroom
The converter comfortably runs sensitive 24 V electronics up to its 12 A rating while maintaining high efficiency to limit heat. At full load the unit reaches its thermal and current limit, so sustained draws above 280 W are not supported. The IP43 rating covers splashing water when mounted correctly, but it does not protect against immersion or pressurised jets.
Highlights
- Stable 24 V output protects sensitive gear
- High-efficiency design reduces energy loss and heat
- IP43 splash resistance suits damp environments when fitted correctly
- Screw terminals enable tool-free wiring
- Isolated 280 W unit handles 12 A for dual-battery systems
Specifications
No published specifications for this item yet.
Questions about this item
What 24 V DC source do I need to power the Orion-Tr 24/24V 12A 280W?
Connect a 24 V DC supply such as a vehicle alternator or a 24 V battery bank to the input terminals; the converter then delivers a regulated 24 V output at up to 12 A.
Will the Orion-Tr 24/24V 12A 280W run alongside my existing 24 V accessories without interference?
The isolated design separates input and output grounds, so the converter can share the same 24 V bus with other loads while preventing ground-loop noise.
How can I verify the Orion-Tr 24/24V 12A 280W is operating correctly after wiring it?
Measure a steady 24 V at the output screw terminals under load and confirm the unit stays cool; the IP43 rating means no water ingress should appear when correctly mounted.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
