Victor
Victor Gas Welding Outfit 0384-0943 with Handle and Goggles
Complete gas welding kit with torch handle, regulators, cutting attachment, 12.5 ft hose, goggles and striker for light fabrication and HVAC work
- MaterialHAWA
- TypeGas Welding Outfits
- Complete gas welding outfit with cutting attachment and regulators
- Includes 12.5 ft dual hose, goggles, striker and tank key
- 90-degree head angle torch handle for versatile positioning
- Compatible with CGA-200 and CGA-540 inlet connections
- Supports Victor 3 series tips for light fabrication and HVAC work
Victor Gas Welding Outfit 0384-0943
This Victor gas welding outfit is a complete acetylene setup for light fabrication and HVAC work. It ships new with a 100FC torch handle, CA1350 cutting attachment, and dual regulators rated for CGA-200 and CGA-540 inlet connections. The kit targets technicians who need a ready-to-use oxygen-fuel system.
Includes 12.5 ft hose, goggles, striker.
The 12.5 ft dual 3/16 in hose connects directly to the R150-200 and R150-540 regulators, while built-in check valves add backflow protection. A Victor 3 series cutting tip and 1-W-1 welding nozzle cover basic cutting and welding tasks. Goggles, a striker, and a tank key mean the operator can start work without sourcing separate safety or setup items.
Check your gas cylinders
Verify that your oxygen and acetylene cylinders carry CGA-540 and CGA-200 valve outlets respectively, as the regulators will not fit other standards. The 90-degree head angle on the torch handle suits bench access but may limit reach in tight ducts. Buyers who need longer hose runs, higher flow capacity, or propane compatibility should look for a different configuration.
Highlights
- Complete gas welding outfit with cutting attachment and regulators
- Includes 12.5 ft dual hose, goggles, striker and tank key
- 90-degree head angle torch handle for versatile positioning
- Compatible with CGA-200 and CGA-540 inlet connections
- Supports Victor 3 series tips for light fabrication and HVAC work
Specifications
| Brand | Victor |
|---|---|
| Material | HAWA |
| Type | Gas Welding Outfits |
Questions about this item
How often should I replace the 12.5 ft dual hose and check valves on this outfit?
Inspect the 12.5 ft dual 3/16 in hose before each use; replace it at the first sign of cracks, abrasion or stiffness. Check valves on the torch handle and regulators should be tested monthly and swapped if they leak or fail to seal.
What limits continuous cutting time with the CA1350 attachment and Victor 3 series tips?
The 90-degree head angle and single-stage regulators (R150-200 and R150-540) deliver steady flow until the acetylene cylinder drops below working pressure; duty cycle is set by gas supply, not the torch itself.
How hot does the 100FC handle get during all-day light fabrication work?
The 100FC handle stays cool enough to hold during extended use; heat is concentrated at the tip and cutting attachment. Regulators and hose remain near ambient temperature when flow is set correctly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
