Victor
Victor FIREPOWER 6700-2590 Cutting Tip GPP-0 Propylene
Propylene cutting tip size 0 for handheld or machine torches, compatible with Victor HC 1200C and ST series torches
- TypeWelding Parts & Supplies
- Cuts steel from 3/8 in to 1/2 in with propylene fuel
- Two-piece tip design fits GPP-0 series torches
- Compatible with HC 1200C and MT 1065 handheld torches
- Works with ST 300FC, ST 400C and ST 900FC machine torches
- Fits CA 2460, CA 2461 and CA 2462 cutting attachments
Victor FIREPOWER 6700-2590 Cutting Tip for Propylene
This Victor FIREPOWER 6700-2590 cutting tip is designed for propylene fuel and fits handheld or machine torches. It belongs to the 1-GPP series with a size 0 two-piece design. The tip handles steel cutting from 3/8 in up to 1/2 in thickness. It suits fabricators and maintenance teams using compatible Victor equipment.
Installation fits listed torch and attachment series
The tip mounts on Victor HC 1200C, MT 1065, MT 5, ST 300FC, ST 400C, ST 900FC, ST 1000FC and ST 2600FC torches. It also pairs with CA 2460, CA 2460+, CA 2461, CA 2461+, CA 2462, CA 2462+ and CA 411-1 cutting attachments. A mismatch with unlisted torch models will prevent proper seating and gas sealing.
Check torch series and fuel type before ordering
Verify that your torch carries one of the model numbers above and that your fuel supply is propylene. The tip will not function with acetylene or other gases. Confirm the required cutting range of 3/8 in to 1/2 in matches the job. California Proposition 65 warning applies to this product.
Highlights
- Cuts steel from 3/8 in to 1/2 in with propylene fuel
- Two-piece tip design fits GPP-0 series torches
- Compatible with HC 1200C and MT 1065 handheld torches
- Works with ST 300FC, ST 400C and ST 900FC machine torches
- Fits CA 2460, CA 2461 and CA 2462 cutting attachments
Specifications
| Brand | FIREPOWER |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
How do I verify the GPP-0 tip is cutting cleanly at the 3/8 in minimum thickness on my HC 1200C torch?
After lighting the propylene flame, make a test cut on 3/8 in steel; a steady, narrow kerf with minimal dross shows the tip is performing to its rated minimum.
Does the box contain only the 6700-2590 tip or are O-rings and a tip nut included?
The package supplies the single two-piece GPP-0 cutting tip; O-rings, tip nuts and the compatible CA 2460 series attachment are sold separately.
When should I choose the size 0 tip instead of a larger GPP series size for my ST 2600FC torch?
Select the size 0 tip when cutting steel between 3/8 in and 1/2 in thick; larger GPP sizes are intended for thicker plate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
