Victor
Victor 0333-0331 Cutting Tip 1 Series Size 10
Two-piece cutting tip for handheld or machine torches, compatible with natural gas and propane, cuts up to 15 in thick material
- TypeWelding Parts & Supplies
- Cuts material up to 15 in thick with size 10 tip
- Two-piece design fits 1-HPN series torches for reliable operation
- Works with natural gas and propane fuels for flexible use
- Compatible with CA 2460, CA 2461, CA 2462 and CA 411-1 attachments
- Suited for fabrication, repair and maintenance welding tasks
Victor Cutting Tip 1 Series Size 10
This Victor cutting tip belongs to the 1-HPN series and carries tip size 10. It is designed for handheld and machine torches used in fabrication, repair and maintenance work. The tip accepts natural gas or propane as fuel. It fits compatible Victor cutting attachments including the CA 2460, CA 2461 and CA 2462 families.
Thermals noise and power draw
The tip is a passive metal component with no moving parts, so it generates no operational noise and draws no electrical power. Heat is produced only by the oxy-fuel flame during cutting. Thermal behaviour depends entirely on the torch setup, fuel mix and cutting duration chosen by the operator.
Build quality and connectors
The two-piece tip design allows the cutting orifice to be replaced separately from the body, reducing long-term consumable cost. It connects directly to Victor CA 2460, CA 2460+, CA 2461, CA 2461+, CA 2462, CA 2462+ and CA 411-1 cutting attachments. Buyers who need a different tip series or a single-piece design will not be served by this model.
Highlights
- Cuts material up to 15 in thick with size 10 tip
- Two-piece design fits 1-HPN series torches for reliable operation
- Works with natural gas and propane fuels for flexible use
- Compatible with CA 2460, CA 2461, CA 2462 and CA 411-1 attachments
- Suited for fabrication, repair and maintenance welding tasks
Specifications
| Brand | VICTOR |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
How do I fit the Victor 0333-0331 tip onto a CA 2460 series cutting attachment, and what is the common mistake?
Screw the two-piece tip firmly onto the compatible CA 2460, CA 2460+, CA 2461, CA 2461+, CA 2462 or CA 2462+ attachment; the step often missed is seating both pieces squarely so the gas seal holds at full pressure.
What part of this tip will wear out first and need replacement during heavy fabrication work?
The two-piece tip end — especially the inner orifice — erodes from the natural-gas or propane flame and must be swapped once the cut edge loses sharpness.
At what plate thickness does this size-10 tip hit its practical limit on a handheld torch?
The tip is rated for a maximum cutting thickness of 15 in; beyond that the pre-heat cone cannot maintain a clean kerf on thick steel.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
