We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black and blue Mini SAS 36-pin male to four SATA female cables, 1.64 ft each

Vibob Store

Vibob Store Mini SAS 36Pin SFF-8087 Male to 4 SATA 7Pin Female Cable 1.64Ft 2pcs

SKU CH-HDCC-9SRPN

Pack of two 1.64 ft Mini SAS 36-pin SFF-8087 male to four SATA female breakout cables for connecting a RAID controller to up to eight SATA drives

  • TypeCable Connectors
  • ColorBlack & Blue
  • Length1.64 ft.
  • Connector Number5
  • Connector Detail1 x SAS to 4 x SATA
  • Terminal GenderMale to Female
  • Connect RAID controller to four SATA drives
  • Two cables support up to eight drives total
  • 64 ft length suits internal cable routing
  • Slim ribbon design reduces airflow obstruction
  • Supports 6Gbs transfer rate per drive

Mini SAS 36Pin SFF-8087 breakout cable

This cable connects a RAID or PCIe controller with an SFF-8087 port to four SATA drives. It is built for system builders expanding internal storage using hardware RAID arrays. Two cables in the pack support up to eight drives across two controller lanes. It suits servers and workstations that use multi-lane SAS host bus adapters.

Passive copper cable with slim ribbon design

The flat ribbon construction reduces airflow obstruction inside the chassis. Woven mesh sheathing covers half the length for protection without adding stiffness. Acetate cloth tape at the fan-out provides strain relief at the connector junctions. No active components or external power are required for operation.

1.64 ft length with dual-cable pack

Each 0.5 metre cable reaches from a controller card to a backplane or drive cage in typical chassis layouts. Two cables enable an eight-drive array using a single dual-port adapter. The forward fan-out orientation simplifies routing to stacked drive bays. Buyers needing longer runs or right-angle connectors should verify case clearance before ordering.

Highlights

  • Connect RAID controller to four SATA drives
  • Two cables support up to eight drives total
  • 64 ft length suits internal cable routing
  • Slim ribbon design reduces airflow obstruction
  • Supports 6Gbs transfer rate per drive

Specifications

TypeCable Connectors
ColorBlack & Blue
Length1.64 ft.
Connector Number5
Connector Detail1 x SAS to 4 x SATA
Terminal GenderMale to Female

Questions about this item

How do I connect the SFF-8087 male end to my RAID controller?

Plug the 36-pin SFF-8087 male connector firmly into the controller port; the four SATA female ends attach to the backplane or drives. Route the 1.64 ft ribbon carefully to avoid sharp bends.

Will the acetate cloth tape or mesh sheath degrade and need replacement?

The tape and woven mesh are passive strain relief; they do not wear out in normal operation. Replace the cable only if connectors loosen or the ribbon shows physical damage.

What throughput ceiling appears first when all four drives run sustained workloads?

Each drive is limited to 6 Gb/s by the SAS-to-SATA breakout; the host link uses PCIe 2.0 x8 lanes, so the per-drive 6 Gb/s cap is reached before the host bandwidth saturates.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.