We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four black steel post anchors with U-shaped brackets and lag bolts

VEVOR

VEVOR UX-3.5-27-4 No Dig Ground Anchor 4 Pack 3.94 x 2.76 x 27.56 in Post Stake

SKU CH-CDZR-WY0JE

Four ground anchors secure 3.5 in timber posts without digging, using 22 in spikes and 24 lag bolts plus a threaded rebar

  • TypeOther Appliances
  • Sturdy support from thickened hard steel construction
  • Powder coating resists corrosion, rust and protects wood from rot
  • Fits 3.5 in timber with 22 in nail depth
  • Complete 4-pack kit includes 24 lag bolts and threaded rebar
  • 56 in total height drives deep for firm anchoring

No-dig ground anchor kit

The VEVOR UX-3.5-27-4 pack contains four steel post stakes designed for 3.5-inch timber. Each anchor measures 3.94 by 2.76 by 27.56 inches with a 22-inch nail length. The set includes 24 M8 screws and one threaded steel bar for secure installation.

Corrosion-resistant powder coating

A powder-coated finish protects the thickened hard steel from soil moisture and rain. The 2.2 mm inner wall and 3 mm fixing plate resist deformation during driving and long-term ground contact. No electrical power or moving parts are involved, so noise and thermal output are not applicable.

Suitable for 3.5-inch lumber

The semi-enclosed spike fits nominal 3.5-inch posts, equivalent to 89 mm. Builders using 4x4 or larger timbers will need a different anchor size. The kit supplies four anchors, so projects requiring more than four post points need additional packs.

Highlights

  • Sturdy support from thickened hard steel construction
  • Powder coating resists corrosion, rust and protects wood from rot
  • Fits 3.5 in timber with 22 in nail depth
  • Complete 4-pack kit includes 24 lag bolts and threaded rebar
  • 56 in total height drives deep for firm anchoring

Specifications

TypeOther Appliances

Questions about this item

How do I install the 27.56 in ground anchor without digging, and what step is often missed?

Drive the 22 in nail section into the ground, slide the 3.5 in timber into the U-shaped holder, then secure it with the 24 supplied M8×60 mm screws and the 15×405 mm threaded rebar; the step most often missed is inserting the rebar through the pre-drilled holes for lateral lock.

What maintenance or replacement will the 4-pack anchors need over time?

The powder-coated 2.2 mm inner wall and 3 mm fixing plate resist rust, so no scheduled replacement is required; periodically check the 24 M8×60 mm screws for tightness after ground movement and touch up any coating damage to maintain corrosion protection.

What limit appears first when the anchor is under sustained wind load on a fence post?

The 22 in nail depth in soil provides the primary holding capacity; in loose or wet ground the anchor will pivot at the base before the 3 mm fixing plate or 2.2 mm inner wall yield, so soil conditions set the practical limit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.