VEVOR
VEVOR Shelf Pilaster 39-inch 10 Pack Single Slot Silver
Ten 39-inch single-slot steel rails with 40 screws and anchors create an adjustable wall shelving system
- TypeOther Appliances
- Maximize storage with 39-inch vertical pilasters
- Adjust shelf height and width for any item
- SPCC steel with powder coat resists rust and scratches
- 40 screws, anchors and manual enable quick assembly
- Suits living room, bedroom, office or retail display
39-Inch Silver Shelf Pilasters 10 Pack
This set includes ten single-slot shelf rails measuring 38.98 inches long, 0.69 inches wide and 0.41 inches deep. Made from SPCC steel with a powder-coated bright silver finish, each rail weighs approximately 0.78 pounds for a total net weight of 7.80 pounds. The kit supplies 40 mounting screws, 40 expansion anchors and 40 wing expansion anchors for installation.
Replaces Fixed-Height Shelving
The vertical single-slot design lets you adjust shelf positions to fit tall décor, stacked books or retail stock without committing to permanent spacing. Upgrading makes sense when you need to reconfigure cabinet or closet layouts frequently and want a heavy-duty steel system that resists scratches, rust and deformation over time.
Check Wall Material and Board Thickness
Verify that your mounting surface can accept the supplied 6x38 mm expansion anchors and M4x50 screws before ordering. The rails are designed for boards up to 1.5 mm thick, so confirm your shelf boards match this specification. Ensure you have 38.98 inches of clear vertical space for each pilaster.
Highlights
- Maximize storage with 39-inch vertical pilasters
- Adjust shelf height and width for any item
- SPCC steel with powder coat resists rust and scratches
- 40 screws, anchors and manual enable quick assembly
- Suits living room, bedroom, office or retail display
Specifications
| Type | Other Appliances |
|---|
Questions about this item
How thick is the wall material needed for the 38.98 in pilasters?
The 1.5 mm SPCC steel rails mount with M4x50 screws and 6x38 expansion anchors, so the wall must accept a 50 mm screw embedment plus anchor depth.
Which step in the manual do users most often skip when mounting the 10 rails?
Pre-drilling the 38 mm anchor holes before driving the M4x50 screws; skipping it splits drywall or leaves loose anchors.
When should the powder-coated finish on the 39-inch rails be touched up?
Inspect yearly; if the silver coating shows white oxidation or exposed steel, clean and apply a matching enamel to stop rust.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



