We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Compact rectangular steel block with chrome hook and rubber handle

VEVOR

VEVOR PML-400 Magnetic Lifter 880 lbs 400 kg

SKU CH-ABW8-G0FTH

Permanent magnetic lifter lifts 880 lbs with a 2.5 safety factor using N42 neodymium magnets

  • TypeOther Appliances
  • Width8.27
  • Lifts 880 lbs of steel with N42 neodymium magnets
  • 5 safety factor gives pull-off force above 2200 lbs
  • Safety switch handle prevents accidental release during operation
  • Chrome-plated steel hook resists rust and deformation under load
  • CE certified for -40 °C to +80 °C working range

Lifting Capacity and Safety

This permanent magnetic lifter uses N42 neodymium magnets to provide an 880 lbs or 400 kg lifting capacity. A 2.5 safety factor and a pull-off force exceeding 2200 lbs or 1000 kg support reliable handling of steel sheets, blocks, rods and cylindrical materials. The unit weighs 20.3 lbs or 9.2 kg and carries CE certification.

Workshop Use and Limitations

The device suits workshops, warehouses and fabrication shops that need to move ferromagnetic plates between 0.2 and 2.2 inches or 5 to 55 mm thick. It is not for buyers who must lift non-magnetic metals such as aluminium or copper, nor for operations requiring powered actuation or remote control. The single-magnet design also limits use on heavily curved or irregular surfaces.

Included Accessories and Practical Impact

The package supplies a pair of gloves and a hex wrench alongside the lifter. The gloves protect hands during positioning and release, while the hex wrench allows on-site adjustment or maintenance of the chrome-plated hook and rotating shaft without sourcing separate tools.

Highlights

  • Lifts 880 lbs of steel with N42 neodymium magnets
  • 5 safety factor gives pull-off force above 2200 lbs
  • Safety switch handle prevents accidental release during operation
  • Chrome-plated steel hook resists rust and deformation under load
  • CE certified for -40 °C to +80 °C working range

Specifications

TypeOther Appliances
Width8.27

Questions about this item

What minimum steel sheet thickness does the PML-400 require for a secure hold?

The lifter is rated for sheet thicknesses between .2 inches and 2.2 inches (5 mm to 55 mm). Thinner material will not develop enough magnetic flux for the 880 lbs capacity.

Will the 880 lbs rated lifter still reach full capacity on a shop crane hook rated for a lower working load?

No. The crane hook and rigging must each be rated for at least the lifter's 880 lbs working load plus the 20.3 lbs lifter weight; otherwise the system capacity is limited by the weakest component.

How can I verify the PML-400 is holding at its rated 2.5 safety factor after positioning it on a load?

Engage the chrome-plated handle until the safety switch locks, then apply a gradual test lift. The load should break free only when force exceeds 2200 lbs (1000 kg), confirming the 2.5 factor.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.