VEVOR
VEVOR MCN70 15° Pneumatic Coil Nailer 45–70 mm 70–120 PSI
Drives 45–70 mm wire-collated coil nails at 70–120 PSI with a 300-nail magazine and 360-degree exhaust for pallet, siding and framing work
- TypeOther Appliances
- Drives 45–70 mm wire-collated coil nails for versatile framing and siding
- Magazine holds 250–300 nails to minimise reloading downtime
- Bumper firing mode enables rapid bump fire with reduced jamming
- 360° adjustable exhaust directs air away from the operator
- Weighs 3.84 kg for easier handling during extended use
15° Pneumatic Coil Nailer 45–70 mm
The VEVOR MCN70 drives wire-collated coil nails from 45 to 70 mm with shank diameters of 2.3 to 2.9 mm and head diameters of 5.5 to 7 mm. It suits tradespeople assembling pallets, crating, fencing, siding and sheathing where high-volume nailing is required.
Magazine capacity and air supply
A side-loading magazine holds 250 to 300 nails at a 7.8 mm spacing, reducing reload frequency on repetitive work. The tool operates at 70 to 120 PSI through a 1/4 inch air inlet and includes a 360° adjustable exhaust, safety trigger and quick-release nose for jam clearance.
Upgrade from stick nailers or lighter coil guns
Builders moving up from stick-fed framing nailers or lower-capacity coil models gain continuous firing with bumper mode and fewer interruptions. The aluminium, steel and plastic body weighs 8.47 lbs, so users needing an ultra-light tool for overhead work all day may prefer a smaller alternative.
Highlights
- Drives 45–70 mm wire-collated coil nails for versatile framing and siding
- Magazine holds 250–300 nails to minimise reloading downtime
- Bumper firing mode enables rapid bump fire with reduced jamming
- 360° adjustable exhaust directs air away from the operator
- Weighs 3.84 kg for easier handling during extended use
Specifications
| Type | Other Appliances |
|---|
Questions about this item
How many 15-degree wire-collated coil nails can the magazine hold before I must reload?
The side-loading magazine accepts 250 to 300 nails at once, so you can drive long runs of 45 mm to 70 mm fasteners without stopping to refill.
What are the noise and heat characteristics when the nailer runs continuously at 70–120 PSI?
The 360-degree adjustable exhaust directs air away from the operator, reducing perceived noise and preventing heat build-up on the aluminum and steel body during all-day pallet, crating or siding work.
What air supply fittings and pressure source must I already have to operate this tool?
You need a compressor that delivers 70–120 PSI through a 1/4-inch air inlet; the package includes M6 and M8 wrenches, lubricating oil and safety goggles, but no hose or coupler.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
