VEVOR
VEVOR Dual Swing Gate Opener 16mm/s 660lbs 18ft AC 50W Remote Kit
Dual 50 W DC 24 V actuators move gates up to 660 lbs and 18 ft at 16 mm/s with IP44 protection, two 65–98 ft remotes, auto-close after 60 s, soft start/stop, photocell reverse and push/pull mounting
- TypeOther Appliances
- Dual 50 W motors open gates at 16 mm/s
- IP44 steel actuators withstand outdoor conditions
- Two remotes control gates from 65-98 ft away
- Auto-close after 60 seconds secures the entrance
- Push or pull installation fits chain link, tube, panel, vinyl and wood gates
Dual Swing Gate Opener Kit
This kit contains two DC 24 V actuators rated at 50 W each with a travel speed of 16 mm/s and a maximum stroke of 15 in. It is built for residential or light-commercial swing gates up to 9 ft long and 661 lbs per leaf.
Gate Weight and Length Capacity
Each actuator supports a single gate leaf weighing up to 661 lbs and measuring up to 9 ft in length. Exceeding either limit will prevent reliable operation and may damage the mechanism.
Remote Control and Safety Features
Two remote controllers operate from 65 to 98 ft away and the system auto-closes after 60 seconds of inactivity. IP44-rated steel housings, soft start/stop, photocell beam auto-reverse and flashing indication light provide outdoor durability and basic safety compliance.
Highlights
- Dual 50 W motors open gates at 16 mm/s
- IP44 steel actuators withstand outdoor conditions
- Two remotes control gates from 65-98 ft away
- Auto-close after 60 seconds secures the entrance
- Push or pull installation fits chain link, tube, panel, vinyl and wood gates
Specifications
| Type | Other Appliances |
|---|
Questions about this item
What does the 16 mm/s actuator speed mean for how fast my gate actually opens?
Each actuator moves at 16 mm/s, so a full 15 inch stroke takes roughly 24 seconds; the gate leaf will open in a similar time depending on mounting geometry.
The kit runs on AC power but the motors are 24 V DC — what does that cap in practice?
The control box converts AC mains to 24 V DC for the motors, limiting each actuator to 50 W and 2 A continuous draw.
What physical clearance and mounting points do I need for the 15 inch travel actuators?
Each actuator needs room for a 15 inch stroke and mounts with the supplied bolt, pin, nut and screw kit on chain-link, tube, panel, vinyl or wood gates.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
