VEVOR
VEVOR Driveway Markers 100Pcs 72 in 5/16 in Dia with 12 in Drill Bit
One hundred orange fiberglass snow stakes, 72 inches tall with dual 10.2-inch reflective bands, plus a 12-inch steel drill bit and gloves
- TypeOther Appliances
- Width7.48
- 360° reflective strips guide vehicles at night
- Fiberglass rods bend and return to shape
- Protective cap enables hammer installation
- 12-inch steel drill bit speeds ground prep
- 100-piece pack covers large driveways
100-Piece Driveway Marker Kit
This kit supplies 100 orange fiberglass poles, each 72 inches long with a 5/16-inch diameter, designed to mark driveways, parking lots and walkways during snow season. Two 10.2-inch reflective bands on every pole return 360-degree visibility under headlights. A 12-inch steel drill bit and a pair of gloves are included for installation.
Fiberglass Build and Mounting Details
The hollow rods use alkali-free fiberglass with unsaturated resin so they flex under pressure and spring back to shape without permanent bending. Each pole carries a black PE cap for hammer driving and a tapered PE tip that eases ground penetration. The caps may loosen after repeated removal but the poles remain stable once seated.
Visibility Range and Ground Limits
Dual acrylic reflective strips, each 5.1 inches wide, create a 360-degree flash that works only when vehicle headlights strike them directly. The 12-inch drill bit suits typical frozen or compacted soil; deeper frost lines or rocky terrain may require a longer auger not supplied in the package.
Highlights
- 360° reflective strips guide vehicles at night
- Fiberglass rods bend and return to shape
- Protective cap enables hammer installation
- 12-inch steel drill bit speeds ground prep
- 100-piece pack covers large driveways
Specifications
| Type | Other Appliances |
|---|---|
| Width | 7.48 |
Questions about this item
How wide are the reflective strips on these 72 in markers?
Each strip is 5.1 in wide and there are two strips per marker, giving 360° visibility at night.
What diameter hole does the included 12 in drill bit make for the 5/16 in poles?
The alloy-steel bit is 0.31 in diameter, matching the 5/16 in fiberglass rods for a tight fit.
Which end goes in the ground first and how do you drive it without splitting the cap?
Place the black PE cap on top and hammer the cap; the tapered PE tip enters the soil while the cap protects the hollow rod.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



