VEVOR
VEVOR 3/4" D-Ring Shackle 2 Pack 62832 lbs Black
Two alloy-steel D-ring shackles rated for a 9500 lb working load and 62832 lb breaking strength, supplied with 7/8" screw pins, isolators and washers
- Width5.91
- Two-pack supplies a spare for every recovery job
- 62 832 lbs breaking strength handles extreme loads
- 9 500 lbs work-load limit keeps daily pulls safe
- Forged #45 steel body resists deformation under stress
- 7/8 in screw pin with isolators reduces vibration noise
VEVOR 3/4" D-Ring Shackle Pair
This pair of alloy steel D-ring shackles is built for vehicle recovery and heavy towing. Each shackle carries a 9500 lbs work load limit and a 62832 lbs breaking strength. The set includes two shackles with 7/8" screw pins, isolators and washers.
Suits off-road recovery and trailer towing
Buyers needing a higher work load limit or a different pin diameter should look elsewhere. The 0.75 in wire diameter and 2.05 in inner diameter fix the fit, so rigs requiring other dimensions will not match this hardware.
7/8" screw pin with 40Cr steel pin
The pin diameter is 22 mm and the pin material is 40Cr steel, while the D-ring uses #45 steel. This single specification decides whether the shackle matches your recovery point and strap loop.
Highlights
- Two-pack supplies a spare for every recovery job
- 62 832 lbs breaking strength handles extreme loads
- 9 500 lbs work-load limit keeps daily pulls safe
- Forged #45 steel body resists deformation under stress
- 7/8 in screw pin with isolators reduces vibration noise
Specifications
| Width | 5.91 |
|---|
Questions about this item
Will the 2.05 in inner diameter and 19 mm wire diameter let these shackles fit the existing recovery points on my older Jeep?
The 2.05 in inner diameter and 19 mm wire diameter match standard 3/4 in D-ring openings, so they will slide onto most factory recovery points that accept a 3/4 in shackle pin.
How do I verify the 28.5 ton break strength is sound after I install the 7/8 in screw pins?
Torque each 7/8 in pin until the red 40Cr steel pin seats flush against the black #45 steel body and the supplied washers sit flat; a visual check that threads are fully engaged confirms proper assembly.
Do the two shackles come with the isolators and washers shown in the title, or must I buy them separately?
The package includes two complete shackles with 7/8 in screw pins, isolators and washers already fitted; no extra hardware is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



