We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of 20 ft red and black 10AWG solar cables with MC4 connectors

VEVOR

VEVOR 10AWG Solar Extension Cable Set 20FT Red/Black IP67

SKU CH-5FXC-1V7XQ

10 AWG tinned-copper extension cables with MC4 connectors carry 30 A at 1500 V, IP67 rated for outdoor solar arrays

  • TypeOther Appliances
  • Width6.3
  • Efficient power transfer with 100% tinned copper 10AWG conductors
  • TÜV certified 10AWG gauge meets international safety standards for solar installations
  • IP67 rating protects against water and dust in harsh outdoor environments
  • Tool-free MC4 connectors enable quick plug-and-play setup for DIY projects
  • 1 m length per cable provides flexible routing for panels, RVs and marine use

10AWG Solar Cable Kit

This 20 ft extension set uses 100 percent tinned copper conductors for low-resistance power transfer. Pre-installed MC4 male and female ends give tool-free plug-and-play installation. The cables are rated for DC 1500 V and 30 A continuous current. TÜV certification confirms compliance with international safety requirements.

Suits fixed off-grid arrays.

Builders wiring rooftop or ground-mount arrays gain the 6.1 m reach and IP67 ingress protection against rain and dust. The XLPE jacket survives operating extremes from -40 °C to 105 °C. Installers needing higher voltage classes or smaller-gauge pigtails must choose a different product.

10AWG gauge decides voltage drop

At 10 AWG the pair handles 30 A with minimal loss over the full 20 ft run. Thinner wire would increase drop and heat; thicker wire adds cost and stiffness without benefit for this current level. The 6.3 mm overall width fits standard MC4 pathways and conduit.

Highlights

  • Efficient power transfer with 100% tinned copper 10AWG conductors
  • TÜV certified 10AWG gauge meets international safety standards for solar installations
  • IP67 rating protects against water and dust in harsh outdoor environments
  • Tool-free MC4 connectors enable quick plug-and-play setup for DIY projects
  • 1 m length per cable provides flexible routing for panels, RVs and marine use

Specifications

TypeOther Appliances
Width6.3

Questions about this item

What connector type and wire gauge does the 20 ft cable use?

Each 20 ft lead is 10AWG and comes with pre-installed MC4 male and female connectors for tool-free plug-and-play connection.

How do I connect the cables without damaging the IP67 seal?

Align the MC4 male and female housings, push straight in until the locking tabs click, then tug gently to confirm engagement; do not twist or use tools, which can compromise the IP67 rating.

When should I inspect or replace the cable set?

Check the XLPE jacket and MC4 seals annually for cracks, UV damage or corrosion, especially after exposure to the -40 °C to 105 °C operating range, and replace any lead that shows degradation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.