Vestil
Vestil FL-LK-8EH floor lock top plate 10 1/2 in caster height
Secures mobile equipment at a 10 1/2 in caster height with a steel top-plate mount
- TypeTraffic & Parking Lot
- Secures equipment at 10 1/2 in caster height
- Retracts to 9 1/2 in for low clearance
- Extends to 10 5/8 in for firm lock
- Fits 8 in wheels with standard bolt pattern
- Steel construction resists wear in parking-lot use
Purpose-built floor lock for 8 in casters
The Vestil FL-LK-8EH secures mobile equipment on level floors when the caster mounting height is 10 1/2 in. Its steel top plate bolts to the equipment frame using the A-pattern spacing of 3-1/8 in by 5-3/8 in inside or 4 in by 6-1/4 in outside. The unit suits warehouses, workshops and loading-dock carts that must stay stationary during loading or assembly.
Extended height locks at 10 5/8 in
When the pedal is engaged the lock drops to 10 5/8 in, lifting the wheel clear of the floor and holding the cart firm under sustained side loads. Retracted height is 9 1/2 in so the caster rolls freely when the lock is released. The all-steel construction resists deformation during repeated daily cycles in industrial traffic areas.
Verify caster height and bolt pattern first
Confirm your casters sit at 10 1/2 in mounting height and use an 8 in wheel diameter before ordering. Measure the existing top-plate bolt holes against the 3-1/8 in by 5-3/8 in inside or 4 in by 6-1/4 in outside spacing. Ensure the mounting surface is flat and rigid enough for the 5 in by 7-1/4 in plate.
Highlights
- Secures equipment at 10 1/2 in caster height
- Retracts to 9 1/2 in for low clearance
- Extends to 10 5/8 in for firm lock
- Fits 8 in wheels with standard bolt pattern
- Steel construction resists wear in parking-lot use
Specifications
| Brand | VESTIL |
|---|---|
| Type | Traffic & Parking Lot |
Questions about this item
Does the 10 1/2 in caster height floor lock generate noticeable vibration or heat during continuous daily use?
The steel floor lock is a passive mechanical brake with no motor or powered components, so it produces no heat, noise or vibration while engaged or disengaged.
What mounting hardware must I already have to install the A-pattern top plate on my equipment?
You need bolts that match the 3-1/8 in by 5-3/8 in inside spacing or the 4 in by 6-1/4 in outside spacing on the 5 in by 7-1/4 in mounting plate.
Will the 8 in wheel diameter specification allow this lock to engage securely on my existing 6 in casters?
No — the lock is designed for 8 in diameter wheels only; using it with smaller casters will prevent the friction pad from contacting the floor properly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
