We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue Cat6 ethernet cable one foot long with molded snagless boots

Vanco

Vanco CAT61BU Cat6 network ethernet cable blue

SKU CH-EAY4-WVMQJ

A 0.3-metre blue Cat6 patch cable with snagless moulded boots, rated at 500 MHz and certified to EIA/TIA 568 A/B for high-speed Ethernet connections

  • 1 ft length suits short patch connections
  • Cat6 rating at 500 MHz supports high-speed data
  • Snagless molded boots protect the RJ45 clips
  • ETL verified and UL listed for safety compliance
  • 100 percent tested to EIA/TIA 568 A/B standards

Ideal for short runs

This one-foot Cat6 patch cable suits home offices or desk setups where the router and computer sit close together. The stranded UTP construction keeps the cable flexible for routing around furniture or through tight cable-management channels. It connects a PC, laptop or console directly to a modem, router, hub or wall plate for high-speed internet, DSL or fast Ethernet links.

Molded boot protects the tab

Each end carries a CAT6-approved RJ45 plug wrapped in a zero-clearance molded boot that prevents the locking tab from snagging during insertion or removal. The snagless strain-relief design reduces stress on the internal conductors when the cable is bent near the connector. ETL verification and UL listing confirm the assembly meets recognized safety and performance standards.

Rated for 500 MHz bandwidth

The cable is 100 percent tested and certified to meet EIA/TIA 568 A/B wiring schemes, supporting data rates up to the 500 MHz rating of the Cat6 specification. Passive copper construction draws no power and adds no audible noise to the environment. Because the run is only one foot, signal loss and thermal effects are negligible in normal indoor use.

Highlights

  • 1 ft length suits short patch connections
  • Cat6 rating at 500 MHz supports high-speed data
  • Snagless molded boots protect the RJ45 clips
  • ETL verified and UL listed for safety compliance
  • 100 percent tested to EIA/TIA 568 A/B standards

Specifications

No published specifications for this item yet.

Questions about this item

What does the 500 MHz rating on this Cat6 cable mean for my connection speed?

The 500 MHz bandwidth supports Gigabit Ethernet and 10 Gigabit Ethernet up to 45 metres, letting you use the full speed of a DSL or cable modem and fast home networking links.

Will the snagless boot and RJ45 plugs fit a standard wall plate or router port without clearance issues?

Yes, the zero clearance molded boot and CAT6 approved RJ45 plugs are designed to seat fully in standard keystone wall plates, router LAN ports, hubs and modem jacks.

How do I install this 1 foot patch cable without damaging the latch tab?

Press the snagless boot tab down firmly with your thumb while inserting the plug until it clicks; pulling the cable body instead of the tab is the common mistake that bends the latch.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.