We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flexible 12 in silver hose with brass compression fittings at both ends

Value Brand

Value Brand Water Connector 3/8 in 125 psi 12 in

SKU CH-P03M-H8RXW

A 12 in water connector with 3/8 in brass compression fittings, 125 psi rating and stainless steel cover

  • Fits 3/8 in hose inside diameter for direct connection
  • Withstands 125 psi at 70 F for reliable pressure handling
  • Operates from 40 to 180 F across hot and cold lines
  • 304 stainless steel cover resists corrosion and wear
  • IAPMO and NSF61 listed for potable water safety

Water Connector 3/8 in 125 psi

The Value Brand water connector joins 3/8 inch hose inside diameter lines with brass F compression fittings on both ends. It suits plumbing installations that require a short, flexible link between rigid pipework or appliances. The 12 inch length fits tight routing where longer hose would kink. Builders needing a different diameter or longer reach will need another part.

Thermals noise and power draw

The PVC tube and 304 stainless steel cover operate continuously from 40 to 180 degrees Fahrenheit at a maximum working pressure of 125 psi measured at 70 degrees Fahrenheit. No pump or motor is present, so the connector adds no noise or electrical draw to the system. Pressure loss across the short run is negligible for typical residential flow rates.

Sustained load behaviour

The hose meets IAPMO and NSF61 standards for potable water contact and holds its 2 3/8 inch bend radius without collapsing during prolonged pressurised service. Brass fittings resist corrosion and maintain seal integrity over repeated thermal cycles. California Proposition 65 warnings apply because the assembly contains a listed chemical.

Highlights

  • Fits 3/8 in hose inside diameter for direct connection
  • Withstands 125 psi at 70 F for reliable pressure handling
  • Operates from 40 to 180 F across hot and cold lines
  • 304 stainless steel cover resists corrosion and wear
  • IAPMO and NSF61 listed for potable water safety

Specifications

BrandZORO SELECT

Questions about this item

How do I install the 3/8 in F compression fittings on this 12 in connector without kinking the hose?

Slide the compression nut and ferrule onto the tube, insert fully into the fitting body, then tighten the nut by hand plus one wrench turn; the 2 3/8 in bend radius prevents sharp kinks during routing.

What maintenance will the PVC tube and 304 stainless cover need over time?

Inspect the silver cover annually for abrasion or corrosion; replace the connector if the PVC tube shows cracking, hardening or leaks at the brass compression fittings.

At what pressure and temperature does the 125 psi rating start to drop during continuous use?

The 125 psi maximum working pressure is rated at 70 F; above that temperature the allowable pressure decreases until the 180 F upper limit of the 40 to 180 F range.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.