We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanized steel vibration strut clamp with TPE cushion, 1 5/8 inch channel width

Value Brand

Value Brand Vibration Strut Clamp 3/4 in Pipe 1 5/8 in W

SKU CH-4F4E-PT2AE

Galvanised steel cushion clamp with TPE lining fits 3/4 in pipe and 1 5/8 in strut channel, rated to 1,000 lb and 275 °F

  • Reduces pipe vibration with TPE cushion insert
  • Galvanized steel resists corrosion in damp environments
  • Supports loads up to 1,000 lb on strut channel
  • Rated for continuous use at 275 degrees Fahrenheit
  • Fits 3/4 inch pipe in 1 5/8 inch strut channel

Vibration-Dampening Strut Clamp

This cushion clamp fits a 3/4 in pipe and mounts on a 1 5/8 in strut channel. A steel body with a galvanised finish provides corrosion resistance, while the TPE cushion absorbs vibration to protect piping systems. It suits installers needing secure, noise-reducing support for copper tube or pipe runs.

Replaces rigid metal clamps

Swapping a standard clamp for this cushioned version cuts vibration transfer and reduces wear on pipe walls. The upgrade is worthwhile when systems run pumps, compressors or flowing fluids that cause movement and noise. Standard clamps remain adequate for static, low-vibration installations.

1,000 lb load capacity and 275 °F limit

The clamp handles heavy pipe loads and elevated temperatures common in commercial plumbing and HVAC. It runs out of headroom when loads exceed the rated capacity or when service temperatures push beyond the maximum operating limit. Always verify the specific application demands against these ratings.

Highlights

  • Reduces pipe vibration with TPE cushion insert
  • Galvanized steel resists corrosion in damp environments
  • Supports loads up to 1,000 lb on strut channel
  • Rated for continuous use at 275 degrees Fahrenheit
  • Fits 3/4 inch pipe in 1 5/8 inch strut channel

Specifications

BrandZORO SELECT

Questions about this item

What strut channel width does this clamp fit?

It mounts in a 1 5/8 in wide strut channel using the built-in strut channel mount type.

How is the clamp installed and what step is often missed?

Slide the cushion onto the pipe, set it in the channel, then tighten the clamp hardware so the TPE cushion grips without crushing the tube.

What part will need replacement after long service?

The TPE cushion can harden or crack after repeated heat cycles up to 275 Degrees F, so plan to swap the cushion insert when vibration increases.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.