Value Brand
Value Brand Transformer Relay DPDT 120V 240V 12A 6A 60A 35A 15A
A DPDT transformer relay for cooling and heating circuits, switching 12 A at 120 V AC and 6 A at 240 V AC with 60 A and 35 A locked-rotor ratings
- DPDT contact form handles cooling and heating circuits
- 12 A full-load at 120 V AC, 6 A at 240 V AC
- 15 A resistive rating at 120 V AC for steady loads
- 60 A locked-rotor at 120 V AC, 35 A at 240 V AC for motor starts
- Surface-mount design with screw terminals for secure wiring
HVAC Transformer Relay for Cooling and Heating
This double-pole double-throw relay switches cooling and heating circuits in HVAC systems. It mounts on a flat surface and connects with screw terminals. The unit is new and ready for installation in compatible control panels.
Resistive 15 A and Motor Load Ratings
At 120 V AC the relay carries 15 A resistive and 12 A full-load current with a 60 A locked-rotor rating. At 240 V AC it handles 6 A full-load and 35 A locked-rotor current. These limits define the motor and heating loads it can reliably control.
Screw Terminal Wiring Simplifies Installation
The screw-terminal block accepts stripped conductors directly without special connectors. Surface mounting lets technicians fasten the relay to a panel or chassis with common hardware. No additional accessories or software are included in the package.
Highlights
- DPDT contact form handles cooling and heating circuits
- 12 A full-load at 120 V AC, 6 A at 240 V AC
- 15 A resistive rating at 120 V AC for steady loads
- 60 A locked-rotor at 120 V AC, 35 A at 240 V AC for motor starts
- Surface-mount design with screw terminals for secure wiring
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
Will the 120V 12A relay contacts work with my existing 24V thermostat circuit?
The relay coil requires 120V AC to operate, so a 24V thermostat cannot drive it directly; a separate 120V control signal is needed.
How can I verify the DPDT relay is switching both poles correctly after wiring it?
Apply 120V AC to the coil and measure continuity across both sets of screw terminals; each pole should change state cleanly when the coil energises.
Does the box include mounting hardware or wire connectors for the screw terminals?
The unit is supplied as a surface-mount relay only; mounting screws and wire ferrules or lugs for the screw terminals must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
