We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rubber speed bump end cap 12in wide 9in long

Value Brand

Value Brand Speed Bump End Cap 29NH36 12in W 9in L Rubber

SKU CH-X576-5YFW5

Rubber end cap completes a speed bump installation on asphalt or concrete surfaces

  • ColorBlack
  • Ends speed bumps cleanly with 12 in wide rubber cap
  • Handles 1 to 5 mph traffic on asphalt and concrete
  • Black rubber resists weather and UV exposure
  • Matches Grainger parts 29NH35 and 29NH40 for system fit
  • Male end cap design completes modular speed bump runs

Male Speed Bump End Cap

This male end cap finishes a speed bump run with a 12 in width and 9 5/8 in length. The rubber construction tolerates vehicle speeds from 1 to 5 mph on asphalt or concrete surfaces. It ships without installation hardware and arrives new in black.

Installers closing a speed bump line

The part suits crews terminating a compatible speed bump section where a male profile is required. Buyers needing a female end cap or a mid-section module should select a different component.

Compatible with Grainger 29NH35 and 29NH40

This end cap is confirmed to fit Grainger part numbers 29NH35 and 29NH40 speed bumps. Verifying the existing bump model against those two numbers is the single check that decides fit.

Highlights

  • Ends speed bumps cleanly with 12 in wide rubber cap
  • Handles 1 to 5 mph traffic on asphalt and concrete
  • Black rubber resists weather and UV exposure
  • Matches Grainger parts 29NH35 and 29NH40 for system fit
  • Male end cap design completes modular speed bump runs

Specifications

ColorBlack
BrandZORO SELECT

Questions about this item

Does the rubber end cap soften road noise from the speed bump over long periods?

The black rubber material absorbs impact and reduces sound transmission when vehicles pass at the rated 1 to 5 mph speed range.

What existing speed bump sections are needed before this end cap can be installed?

It is designed to finish a run of compatible speed bump modules such as the 29NH35 or 29NH40 sections.

Will the 12 in width and 9 5/8 in length match the profile of older speed bump pieces already on site?

The cap aligns with the standard 12 in width and 2 1/2 in height used on the compatible 29NH35 and 29NH40 models.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.