Value Brand
Value Brand Miniature Indicator Light Red 120V 20C859
A red neon panel indicator light for 120V AC circuits, 5/16 in mounting diameter with 6 in wire leads, 2 mA draw and 25,000-hour rated life
- Red indicator shows status at a glance
- 120 V AC neon suits mains-powered panels
- 25,000-hour average life reduces replacement frequency
- IP40 rating protects against solid ingress
- UL listed and CSA certified for safety compliance
Miniature Indicator Light 120V Red
The Value Brand miniature indicator light is a neon panel lamp with a red polycarbonate lens and a nylon body. It mounts in a 5/16 inch diameter hole and connects through six inch wire leads. The unit draws two milliamps at 120 volts AC and carries CSA and UL listings with an IP40 rating. Average life is rated at twenty five thousand hours.
Suits panels needing a compact pilot lamp
This light fits panels at least point zero three inches thick and is intended for equipment that requires a simple on or off indication. It is not for installations that need a different voltage, a different lens colour or a higher environmental rating than IP40. Buyers who want a brighter LED alternative or a larger mounting diameter should look at other products.
Verify panel cut out and wiring before ordering
Check that the mounting hole matches the 5/16 inch diameter and that the panel thickness meets the minimum requirement. Confirm the supply voltage is 120 volts AC and that the six inch leads can reach the termination point. The product contains chemicals listed under California Proposition 65 for cancer and reproductive harm.
Highlights
- Red indicator shows status at a glance
- 120 V AC neon suits mains-powered panels
- 25,000-hour average life reduces replacement frequency
- IP40 rating protects against solid ingress
- UL listed and CSA certified for safety compliance
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What panel cut-out do I need for the 5/16 in mounting diameter?
Drill a 5/16 in hole; the light fits panels from .030 in thick and carries a NEMA 1 / IP40 rating.
Will the 6 in wire leads reach a standard 120V terminal block?
The 6 in leads are sized for typical panel wiring; strip and connect to your 120V AC supply.
How can I verify the neon lamp is operating correctly after installation?
Apply 120V AC — the red lens should glow steadily at 2 mA draw, indicating normal function.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



