We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White plastic J-bend trap with slip nuts and washers

Value Brand

Value Brand J-Bend Trap 1-1/4" or 1-1/2" White Plastic

SKU CH-1F7E-QG4NP

A white plastic J-bend trap fitting 1-1/4" or 1-1/2" slip connections with included slip nut and washer

  • ColorWhite
  • White finish suits visible plumbing installations
  • J-bend design creates effective water seal against sewer gas
  • Slip connections on both ends simplify installation without threading tools
  • Polypropylene construction resists corrosion from common drain chemicals
  • Fits both 1-1/4 inch and 1-1/2 inch nominal pipe sizes

White Plastic J-Bend Trap for 1-1/4" or 1-1/2" Pipe

This J-bend trap connects sink drains in residential and light-commercial plumbing. The white polypropylene body resists corrosion and fits nominal pipe sizes of 1-1/4 in and 1-1/2 in. Slip-joint connections on both inlet and outlet allow tool-free alignment during installation. A slip nut and washer are included for immediate use.

Replaces worn metal or cracked plastic traps

The dual-size slip ends slide over existing 1-1/4 in or 1-1/2 in drain pipes, so the upgrade is worth it when the old trap leaks, corrodes or no longer seals. No threading is required because the inlet and outlet both use slip connections. The 7-3/4 in overall length fits standard sink rough-ins.

Slip-joint design limits use to accessible.

The trap relies on compression washers rather than solvent weld or threaded joints, so it must remain accessible for future tightening or replacement. It is not rated for pressurised supply lines or buried installations. California Proposition 65 warnings apply because the material contains a chemical known to cause cancer and birth defects or other reproductive harm.

Highlights

  • White finish suits visible plumbing installations
  • J-bend design creates effective water seal against sewer gas
  • Slip connections on both ends simplify installation without threading tools
  • Polypropylene construction resists corrosion from common drain chemicals
  • Fits both 1-1/4 inch and 1-1/2 inch nominal pipe sizes

Specifications

ColorWhite
BrandZORO SELECT

Questions about this item

What size slip nuts does the 1-1/4" or 1-1/2" J-bend trap accept?

The trap uses slip connections for both inlet and outlet, and it includes slip nuts and washers sized for 1-1/4" and 1-1/2" nominal pipe.

How do I install the J-bend without leaking at the slip joints?

Slide the supplied nut and washer onto each pipe, insert the pipe fully into the hub, then hand-tighten the nut plus a quarter turn with pliers; over-tightening cracks the plastic.

When should I replace the included slip-joint washers?

Replace the washers whenever the trap is removed for cleaning or if you see seepage at the nuts; the white polypropylene body itself does not degrade under normal drain use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.