Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00919927BTC
In stock
Value Brand
Value Brand Brass Street Tee 10PK
Pack of ten brass street tees with FNPT x MNPT x FNPT connections, rated to 1200 psi and -65 to 250 °F
- TypeOther
- 10-pack covers multiple fittings in one order
- Brass body resists corrosion in water lines
- Class 150 rating handles 1200 psi working pressure
- Operates from -65 °F to 250 °F for wide temperature range
- FNPT x MNPT x FNPT ends connect without adapters
Brass Street Tee Pack
This pack contains ten brass street tees with 3/8 inch FNPT x MNPT x FNPT connections. They suit plumbers and maintenance teams joining three pipe sections in water, air or inert-gas lines. The Class 150 rating covers standard low-pressure distribution tasks. Buyers needing larger diameters or different thread types must select alternative fittings.
Thermals Noise and Power
Brass construction handles a temperature range from minus 65 to 250 degrees Fahrenheit without degradation. The material does not generate heat, noise or electrical draw because it is a passive fitting. Pressure capacity reaches 1200 psi within the stated temperature limits. Systems operating outside this range require different components.
Sustained Load Behavior
Under continuous pressure up to 1200 psi the tees maintain seal integrity across the full temperature span. Brass resists stress corrosion and creep during prolonged service in compliant fluids. The ASA, ASME and SAE standards confirm dimensional stability for repeated thermal cycles. Installations exceeding the rated pressure or temperature envelope are not supported.
Highlights
- 10-pack covers multiple fittings in one order
- Brass body resists corrosion in water lines
- Class 150 rating handles 1200 psi working pressure
- Operates from -65 °F to 250 °F for wide temperature range
- FNPT x MNPT x FNPT ends connect without adapters
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Questions about this item
How do I install the 3/8" FNPT x MNPT x FNPT brass street tee without cross-threading?
Start each thread by hand, turn the male NPT end clockwise until finger-tight, then use a wrench for one to two additional turns; over-tightening distorts the brass threads and causes leaks.
What maintenance will the brass street tee need over time?
Inspect joints annually for green corrosion or seepage; re-apply PTFE tape or pipe dope and re-tighten if any weep appears, otherwise the Class 150 brass body requires no scheduled replacement.
At what pressure limit does the fitting reach its 1200 psi rating under sustained use?
The ASA/ASME/SAE rating caps continuous service at 1200 psi; exceeding this pressure risks permanent deformation of the brass body even within the -65 to 250 °F temperature range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
