Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Value Brand
A brass coupling joins two 3/4 inch female NPT threads at Class 150 pressure rating
This brass coupling joins two sections of 3/4 inch female NPT pipe in residential and light-commercial plumbing systems. The Class 150 rating suits standard water and air lines found in bath and utility installations. Supplied in a pack of five, it covers multiple connection points in a single purchase. The product is new and ready for immediate installation.
Brass construction conducts heat evenly across the joint, so the fitting tracks the temperature of the fluid inside without creating local hot spots. The Class 150 designation indicates the pressure envelope the coupling is designed to contain under normal service conditions. No moving parts or seals are present, so the joint adds no vibration or noise to the pipe run. Power draw is not applicable to this passive component.
The coupling is machined from brass with female NPT threads on both ends, allowing direct engagement with matching male-threaded pipe or fittings. A Proposition 65 notice applies because the brass alloy contains a chemical listed by the State of California as a potential health concern. Installers should follow local code requirements for thread sealant and torque to ensure a leak-free joint. The five-piece pack simplifies inventory for projects needing several identical connections.
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Wrap PTFE tape clockwise on the male threads, hand-tighten the coupling, then turn one to two full turns with a wrench; the step most people skip is cleaning both thread sets first so grit does not cut the brass.
Inspect the joint annually for green corrosion or weeping; if the threads show pitting or the seal drips, replace the coupling — brass does not require lubrication but it cannot be re-sealed once the threads deform.
Sustained pressure at the Class 150 rating causes gradual brass creep, so the joint will begin to weep at the threads before the material fractures or the NPT seal fails catastrophically.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?