Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00947486BTC
In stock
Value Brand
Value Brand 90 Degrees Street Elbow Brass 1/4 in 200 psi
90-degree brass street elbow connects 1/4 inch male and female threads at 200 psi maximum pressure
- TypeOther
- 90-degree turn routes pipe in tight spaces
- 1/4 inch male and female threads fit standard fittings
- 200 psi rating handles typical residential pressure
- Class 125 brass resists corrosion
- California Proposition 65 warning applies
90 Degree Brass Street Elbow
This brass street elbow provides a 90 degree change of direction in plumbing systems. It features a 1/4 inch male threaded end and a 1/4 inch female threaded end. The fitting is rated for a maximum operating pressure of 200 psi. It suits installers needing a compact corner connection in water or air lines.
Class 125 Pressure Rating and Headroom
Rated at Class 125, the elbow handles up to 200 psi maximum operating pressure. This capacity covers standard residential and light commercial water supply pressures. The fitting runs out of headroom in high-pressure hydraulic or industrial steam systems exceeding this limit. Installers should verify system pressure stays within the rated maximum before use.
Red Brass Construction and Threaded Ends
The red brass body resists dezincification and corrosion in potable water applications. Male and female NPT threads allow direct connection to pipes, valves or adapters without extra couplings. The street configuration saves space in tight wall cavities or manifold assemblies. California Proposition 65 warnings apply for chemicals known to cause cancer and reproductive harm.
Highlights
- 90-degree turn routes pipe in tight spaces
- 1/4 inch male and female threads fit standard fittings
- 200 psi rating handles typical residential pressure
- Class 125 brass resists corrosion
- California Proposition 65 warning applies
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Questions about this item
Will this 1/4 in threaded elbow connect to the existing brass nipples I already have?
The elbow has a 1/4 in male threaded end and a 1/4 in female threaded end, so it mates with standard 1/4 in NPT brass nipples and fittings.
How can I confirm the joint is holding at the rated 200 psi after installation?
Pressurise the system to its working pressure and inspect the threaded connection for leaks; the Class 125 brass body is rated for 200 psi maximum operating pressure.
Does the package include thread sealant or tape, or must I buy them separately?
Only the street elbow is supplied; thread sealant or PTFE tape must be purchased separately to make the threaded joints watertight.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
