Value Brand
Value Brand 6AFP3 Hose Barb 1/2 in x 3/8 in FNPT Brass
Brass barbed hose fitting connects 1/2 inch hose to 3/8 inch FNPT, rated to 300 psi for low-pressure pneumatic and water lines
- Brass construction resists corrosion for long service life
- Straight body design directs optimal flow through the fitting
- 1/2 in barb to 3/8 in FNPT connects hose to threaded port
- Rated to 300 psi for low-pressure pneumatic and water lines
- California Proposition 65 warning applies to this product
Brass hose barb for low-pressure lines
The ZORO SELECT 6AFP3 is a straight brass barbed fitting that joins a 1/2 inch hose to a 3/8 inch female NPT thread. It is built for low-pressure pneumatic and water systems where a simple, rigid connection is required. The fitting contains no shut-off valve and is not rated for vacuum use.
Check thread size and pressure rating
Verify that the mating port is a 3/8 inch female NPT thread and that the hose inner diameter matches the 1/2 inch barb. The component is rated to a maximum pressure of 300 psi, so confirm your system operates below that limit. California Proposition 65 warnings apply because the brass contains listed chemicals.
Brass construction resists corrosion
The all-brass body withstands a variety of environmental conditions and helps maintain a leak-free seal over time. A straight profile keeps flow unrestricted and simplifies routing in tight spaces. Because there is no integrated valve, plan for a separate shut-off if the application demands one.
Highlights
- Brass construction resists corrosion for long service life
- Straight body design directs optimal flow through the fitting
- 1/2 in barb to 3/8 in FNPT connects hose to threaded port
- Rated to 300 psi for low-pressure pneumatic and water lines
- California Proposition 65 warning applies to this product
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
Does the 6AFP3 hose barb come with clamps or thread sealant, or must I buy them separately?
The fitting is sold alone; hose clamps and thread sealant are not included and must be purchased separately.
Should I choose the 1/2 inch barb with 3/8 inch FNPT or a different size for my air line?
Select this version when your hose has a 1/2 inch inner diameter and the mating port is a 3/8 inch female NPT thread.
Will the 300 psi rating hold at the compressor tank or only at the tool end?
The brass fitting is rated for 300 psi maximum working pressure at any point in the low-pressure pneumatic circuit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
