We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Galvanised malleable iron 45 degree elbow with NPT threads

Value Brand

Value Brand 45° Elbow 3/8" NPT Malleable Iron Class 150

SKU CH-J5VJ-E8DMZ

A 45-degree galvanized malleable iron elbow with 3/8 inch NPT female threads, rated Class 150

  • 45° flow change in tight pipe runs
  • Malleable iron construction handles Class 150 pressure rating
  • Galvanised finish resists corrosion in water systems
  • 3/8" NPT female threads on both ends
  • California Proposition 65 chemical warning applies

Application & Suitability

This 45° elbow fitting connects two 3/8" NPT female threads in piping systems rated to Class 150. It suits installers who need a galvanised malleable iron joint for water, gas or air lines where a moderate directional change is required. Buyers needing a different angle, larger bore or higher pressure class should select an alternative fitting.

Critical Specification

The fitting is manufactured from galvanised malleable iron to Class 150 with a 45° sweep and 3/8" NPT female threads on both ends. This pressure class and thread combination is the single detail that determines whether the part matches the system design; verify both values against your project specification before ordering.

Installation Notes

Thread sealant or tape must be applied to the male threads before engagement to ensure a leak-free seal. Over-tightening can crack the malleable iron body, so tighten to the recommended torque for 3/8" NPT rather than forcing the joint. The galvanised coating resists corrosion but should be inspected for damage before installation.

Highlights

  • 45° flow change in tight pipe runs
  • Malleable iron construction handles Class 150 pressure rating
  • Galvanised finish resists corrosion in water systems
  • 3/8" NPT female threads on both ends
  • California Proposition 65 chemical warning applies

Specifications

BrandZORO SELECT

Questions about this item

What does the 45-degree angle mean for flow direction in my piping?

The 45-degree elbow changes flow direction at a gentler angle than a right-angle fitting, which can reduce turbulence in plumbing runs.

What does the NPT threading and Class 150 rating cap in practice?

The 3/8 inch NPT female threads mate with matching male pipe threads, and the Class 150 rating indicates the pressure class for this malleable iron fitting.

What physical space and connection type does this elbow need to fit?

It requires two 3/8 inch male NPT threaded ports and installs as a female-to-female connection in a galvanized malleable iron assembly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.