Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00933443BTC
In stock
Value Brand
Value Brand 45 Degree Street Elbow Brass 1/4 in 10 Pack
A pack of ten 45-degree brass street elbows with 1/4-inch threaded male and female ends rated Class 150
- TypeOther
- 45-degree brass elbow directs flow efficiently in tight spaces
- Class 150 rating handles standard residential pressure demands
- 1/4-inch male and female NPT threads connect without adapters
- Brass construction resists corrosion for long service life
- Ten-piece pack covers multiple joints in one purchase
Plumbing Fitting Pack
This pack contains ten brass street elbows built for plumbing systems that require a 45-degree directional change. Each fitting joins a 1/4-inch male threaded end to a 1/4-inch female threaded end. The brass construction suits water and gas lines in residential or light commercial installations.
Threaded Connection Upgrade
These elbows replace separate couplings and bends when a compact turn is needed in tight pipe runs. The street design lets one end thread directly into a female port without an extra nipple. The step is worthwhile when reducing joint count and potential leak paths matters for the installer.
Class 150 Pressure Limit
Rated to Class 150, the fittings handle standard low-pressure plumbing duties but are not suited for high-pressure hydraulic or steam circuits. Brass resists corrosion in potable water yet contains chemicals flagged under Proposition 65. Verify local code acceptance before specifying for drinking-water systems.
Highlights
- 45-degree brass elbow directs flow efficiently in tight spaces
- Class 150 rating handles standard residential pressure demands
- 1/4-inch male and female NPT threads connect without adapters
- Brass construction resists corrosion for long service life
- Ten-piece pack covers multiple joints in one purchase
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Questions about this item
What thread sizes must my existing fittings have to accept these 1/4 in elbows?
Each elbow has a 1/4 in male threaded end and a 1/4 in female threaded end, both using 18 threads per inch, so the mating parts must match that size and pitch.
How do I install a street elbow without stripping the brass threads?
Apply PTFE tape or pipe dope to the male threads only, hand-tighten the joint, then finish with a wrench no more than one to two turns to avoid over-torquing the soft brass.
When should I plan to replace these Class 150 brass elbows?
Inspect annually for greenish corrosion, thread wear or seepage at the joint; replace any fitting that shows pitting, leakage or cannot hold the rated Class 150 pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
