We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Stainless steel cam-and-groove adapter with male threads and female NPT end

Value Brand

Value Brand 3LX10 1-1/2" Male Adapter x FNPT 316 SS Coupling

SKU CH-ZW0J-HNTR5

316 stainless steel cam-and-groove adapter with 1-1/2 inch FNPT thread rated for 250 psi at 70°F

  • Corrosion-resistant 316 stainless steel construction
  • Secure NPT thread connection for leak-free joints
  • 250 psi working pressure at 70 °F
  • Compact 2-5/32 inch overall length fits tight spaces
  • 1-1/2 inch coupling size matches standard plumbing requirements

1-1/2" 316 Stainless Steel Adapter

The Value Brand 3LX10 is a Type A cam-and-groove adapter with a male plug and a female NPT thread. Both ends share a 1-1/2 inch nominal size and the thread follows a 1-1/2 in -11-1/2 standard. The body is machined from 316 stainless steel for corrosion resistance in fluid handling systems.

Thermals Noise Power

This is a passive mechanical fitting with no moving parts, electrical draw or active cooling. It produces no audible noise and generates no heat during normal operation. The maximum rated working pressure is 250 psi at 70 F.

Included Hardware Software

The adapter ships as a single component without a locking arm, gasket or additional hardware. No software, drivers or digital tools are supplied or required for installation. The product carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm.

Highlights

  • Corrosion-resistant 316 stainless steel construction
  • Secure NPT thread connection for leak-free joints
  • 250 psi working pressure at 70 °F
  • Compact 2-5/32 inch overall length fits tight spaces
  • 1-1/2 inch coupling size matches standard plumbing requirements

Specifications

BrandZORO SELECT

Questions about this item

How do I install the 1-1/2" NPT male adapter without cross-threading the 11-1/2 TPI threads?

Clean both thread sets, apply PTFE tape clockwise on the male end only, hand-tighten until resistance rises, then turn one to two full turns with a wrench on the hex flats — do not back off to align.

What maintenance does the 316 stainless cam-and-groove coupling need after repeated pressure cycles?

Inspect the groove and arm pocket for deformation, replace the Buna-N gasket when it takes a set, and verify the 250 psi rating at 70 °F has not been exceeded during service.

At what pressure does the 316 SS body reach its published limit during continuous operation?

The maximum working pressure is 250 psi at 70 °F; sustained use above that value or at higher temperatures reduces the safety margin and requires a lower-rated system design.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.