Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.0093209BTC
In stock
Value Brand
Value Brand 3 in 150 psi PVC Ball Valve
Manual two-way PVC ball valve handles water at 150 psi with lever control
- TypeOther
- Manual two-way flow control for water systems
- PVC body and ball resist corrosion in wet environments
- 150 psi operating pressure suits residential plumbing
- Lever handle allows quick open and close action
- California Proposition 65 warning for chemical exposure awareness
3 Inch PVC Ball Valve
This Zoro Select manual two-way ball valve uses a straight PVC body rated for water service at up to 150 psi. The two-piece construction and standard port design suit basic on-off flow control in plumbing and irrigation systems. A non-locking lever handle operates the PVC ball inside the socket-end connections.
Residential And Light Commercial Installers
The valve fits installations that need simple shut-off for cold water lines at moderate pressure. Buyers who need steam service, combustible gas rating, vacuum capability or 3-A sanitary compliance should look at a different product. The socket ends require solvent welding rather than threaded or flanged connections.
150 Psi Pressure Rating
The maximum operating pressure of 150 psi is the single figure that determines whether this valve matches the system design. California Proposition 65 warnings apply because the product contains chemicals known to cause cancer and reproductive harm.
Highlights
- Manual two-way flow control for water systems
- PVC body and ball resist corrosion in wet environments
- 150 psi operating pressure suits residential plumbing
- Lever handle allows quick open and close action
- California Proposition 65 warning for chemical exposure awareness
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Questions about this item
What size PVC pipe and solvent cement do I need to join the 3 in nominal valve sockets?
The valve uses 3 in nominal socket ends; match them with 3 in PVC pipe and use PVC primer and cement rated for pressure pipe to make the joints.
Will the 150 psi pressure rating handle the same water pressure as my existing 1 in copper supply lines?
The valve is rated for 150 psi maximum operating pressure with water; verify your system pressure stays below that limit before connecting it to any existing piping.
How can I confirm the valve is sealing correctly after I solvent-weld it into the line?
Pressurise the line up to the design pressure, then inspect each solvent-welded joint and the lever handle area for visible leaks while the handle is in both open and closed positions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
