Value Brand
Value Brand 24T955 Repair Clamp 3/4" Partial Coverage 6"L
Stainless steel clamp with nitrile gasket seals 3/4 inch pipe at up to 150 psi
- Stainless steel 304 body resists corrosion
- Nitrile rubber gasket seals up to 150 psi
- Partial coverage design fits 3/4 in pipe
- Two steel bolts provide secure fastening
- Ready for immediate installation
Ideal for 3/4" pipe repairs
This repair clamp fits a 3/4 inch pipe with a 1 1/16 inch outside diameter. The partial-coverage nitrile gasket seals localised leaks without replacing the pipe section. Plumbers and maintenance crews use it for quick, permanent fixes on copper or steel lines.
Rated for 150 psi service
The 304 stainless-steel band and two steel bolts hold 150 psi working pressure and equal vacuum. The six-inch length distributes clamping force evenly so the joint stays tight under normal pressure cycles. No special tools are needed beyond standard wrenches.
Includes two steel bolts
Grade 304 stainless construction resists corrosion in water and chemical environments. The nitrile gasket handles typical plumbing fluids across a wide temperature range. The clamp ships ready to install with no extra components required.
Highlights
- Stainless steel 304 body resists corrosion
- Nitrile rubber gasket seals up to 150 psi
- Partial coverage design fits 3/4 in pipe
- Two steel bolts provide secure fastening
- Ready for immediate installation
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
How do I install the 3/4 inch repair clamp and what is the common tightening mistake?
Center the 304 stainless steel clamp over the 1 1/16 inch outside diameter pipe, align the nitrile rubber gasket, then tighten the two steel bolts evenly in small increments to avoid pinching the gasket and creating a leak path.
What maintenance or replacement will the clamp need over time?
Inspect the nitrile rubber gasket periodically for cracking or hardening from pressure cycles up to 150 psi; replace the gasket or the entire clamp if the seal degrades or the stainless steel shows corrosion.
What is the first limit reached under sustained pressure use?
The 150 psi maximum operating pressure is the primary limit; exceeding it risks gasket extrusion or bolt failure before any other component gives way.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



