Value Brand
Value Brand 24T946 Repair Clamp Single Bolt 3/4 In 304 SS
Single-bolt 304 stainless clamp with nitrile gasket seals 3/4 in pipe at up to 150 psi
- Single-bolt design speeds up pipe repairs
- 304 stainless steel resists corrosion in wet environments
- Nitrile rubber gasket seals up to 150 psi pressure
- Fits 3/4 inch pipe with 1 1/16 inch outside diameter
- Partial gasket coverage targets the leak area directly
Repair Clamp for 3/4 Inch Pipe
The Value Brand 24T946 is a single-bolt repair clamp designed for 3/4 inch pipe with an outside diameter of 1 1/16 in. It uses a 304 stainless steel band and a nitrile rubber gasket to seal leaks at up to 150 psi. The clamp provides partial gasket coverage for targeted repairs.
Replaces Temporary Leak Fixes
This clamp upgrades from tape or epoxy putty by delivering a reusable mechanical seal that installs with one bolt. The jump is worth it when a permanent, pressure-rated repair is needed on copper or steel lines without cutting the pipe. It is not for buyers who need full-circumference gasket coverage.
Limited by Single-Bolt Design
The single bolt applies clamping force at one point, so sealing relies on gasket compression across a partial wrap. This limits effectiveness on heavily corroded or ovalised pipe where uniform pressure cannot be achieved. The 150 psi rating applies only when the pipe OD matches 1 1/16 in exactly.
Highlights
- Single-bolt design speeds up pipe repairs
- 304 stainless steel resists corrosion in wet environments
- Nitrile rubber gasket seals up to 150 psi pressure
- Fits 3/4 inch pipe with 1 1/16 inch outside diameter
- Partial gasket coverage targets the leak area directly
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
What pipe outside diameter does the 3/4 in repair clamp fit?
The clamp fits a pipe outside diameter of exactly 1 1/16 in, as both the minimum and maximum outside diameter are 1 1/16 in.
How do I install the single-bolt clamp and what is the common mistake?
Place the clamp over the pipe with the gasket centred on the leak, then tighten the single steel bolt evenly; the common mistake is over-tightening, which can distort the 304 stainless steel band.
When should I replace the nitrile rubber gasket on this clamp?
Replace the nitrile rubber gasket if it shows cracking, hardening or loss of elasticity, especially after exposure to temperatures or chemicals beyond its rated service.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



