Value Brand
Value Brand 24M042 Round Indicator Light Red 12V DC
Red LED indicator light mounts in an 8 mm panel hole and operates on 12 V DC drawing 20 mA
- Engine BrandZORO SELECT
- Engine Size8mm Mounting dia
- Red LED indicator light for clear visual status
- 12 V DC operation suits automotive and industrial panels
- 8 mm mounting diameter fits standard panel cut-outs
- 20 mA current draw keeps power consumption low
- 100 000 hour average life reduces replacement frequency
Red 12 V DC Indicator Light
This 8 mm round panel light uses a red LED behind a brass-plated chrome bezel. It mounts in panels up to 0.160 in thick and connects with a 0.11 male quick-disconnect terminal. The light draws 20 mA at 12 V DC and carries a cRUus listing plus RoHS compliance. An IP40 rating protects against solid objects larger than 1 mm.
Upgrade From Incandescent Pilot Lamps
The LED source lasts up to 100,000 hours, far longer than filament bulbs that burn out and need frequent replacement. Low 20 mA current draw reduces load on control circuits and battery-backed systems. The switch is worth it when panels vibrate, when maintenance access is difficult or when power budget is tight.
Limits Of IP40 And Quick-Disconnect Wiring
IP40 blocks dust but offers no water protection, so the light must stay inside a sealed enclosure or dry cabinet. The 0.11 male quick-disconnect suits solid wire or crimp terminals but is not rated for high-vibration harnesses without a secondary lock. Continuous 12 V DC operation is required; AC or higher-voltage circuits will damage the LED.
Highlights
- Red LED indicator light for clear visual status
- 12 V DC operation suits automotive and industrial panels
- 8 mm mounting diameter fits standard panel cut-outs
- 20 mA current draw keeps power consumption low
- 100 000 hour average life reduces replacement frequency
Specifications
| Engine Brand | ZORO SELECT |
|---|---|
| Engine Size | 8mm Mounting dia |
Questions about this item
What size panel cut-out does the 8 mm mounting diameter require?
Drill an 8 mm hole; the light fits panels up to 0.160 in thick.
How do I connect the 0.11 male quick-disconnect terminals without special tools?
Push the matching female quick-disconnects onto the tabs until they click; no soldering or crimping needed.
When should I plan to replace the LED given its 100 000 hour average life?
At 12 V DC drawing 20 mA, the LED lasts roughly 100 000 hours; replace when brightness drops noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



