We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass straight bushing, 1/2 inch male to 1/8 inch female NPT threads

Value Brand

Value Brand 22UL37 Brass Bushing 1/2 Male NPT 1/8 Female NPT

SKU CH-SXDH-DVPWC

Brass bushing reduces 1/2 in Male NPT to 1/8 in Female NPT for 200 psi plumbing systems

  • Brass construction resists corrosion for long service life
  • 1/2 in male NPT to 1/8 in female NPT adapts pipe sizes
  • Straight-thread design simplifies installation in tight spaces
  • Rated for 200 psi maximum operating pressure
  • California Proposition 65 warning applies to this product

Brass Bushing 1/2 Male NPT 1/8 Female NPT

This brass bushing reduces a 1/2 inch male NPT thread down to a 1/8 inch female NPT thread. It is suited for plumbers and maintenance technicians adapting pipe sizes in fluid-handling systems. The straight body allows direct installation without extra fittings.

Thermals Noise and Power Draw in Normal Use

The fitting is a passive brass component with no moving parts, electrical draw or cooling requirements. It produces no audible noise and generates no heat during operation. Pressure containment is rated to 200 psi maximum operating pressure under normal service conditions.

Replaces Larger Female Threaded Ports

This bushing replaces the need for a larger female port when a smaller 1/8 inch female connection is required on a 1/2 inch male pipe end. The jump is worth it when reducing port size in brass piping systems without introducing additional leak paths or assembly length. It is not for buyers who need a different thread standard or a higher pressure rating than 200 psi.

Highlights

  • Brass construction resists corrosion for long service life
  • 1/2 in male NPT to 1/8 in female NPT adapts pipe sizes
  • Straight-thread design simplifies installation in tight spaces
  • Rated for 200 psi maximum operating pressure
  • California Proposition 65 warning applies to this product

Specifications

BrandZORO SELECT

Questions about this item

How do I install the 1/2 in Male NPT end without cross-threading?

Start the brass bushing by hand for at least three full turns before using a wrench; the 1/2 in Male NPT taper will seal when the threads bottom out.

Will the brass threads need replacement from dezincification?

Brass resists dezincification in typical water systems; inspect annually and replace only if green powder appears on the 1/8 in Female NPT threads.

At what pressure does the 200 psi rating become the limiting factor?

The 200 psi Maximum Operating Pressure is the first limit reached; sustained pressure above that value can cause the brass bushing to leak or crack.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.