Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00907765BTC
In stock
Value Brand
Value Brand 1 in Brass Gate Valve 200 psi
Brass gate valve with a non-rising stem and wheel handle rated for 200 psi water and 125 psi steam
- Size1"
- TypeOther
- Brass body resists corrosion for long service life
- 200 psi rating handles typical residential water pressure
- Non-rising stem fits tight installation spaces
- Wheel handle gives clear on/off control
- Screw-in bonnet allows straightforward maintenance access
1-Inch Brass Gate Valve
This 1-inch brass gate valve is designed for water supply lines in residential and commercial plumbing. It features a solid brass wedge and brass stem with a non-rising design operated by a wheel handle. The screw-in bonnet and NPT female threads allow direct installation onto standard pipe fittings.
Suits standard water service lines
The valve handles cold and hot water up to 200 psi and saturated steam up to 125 psi. Builders needing a valve for higher pressure ratings, different media such as gas or oil, or a rising stem for visual position indication should select another model. It is also unsuitable for systems requiring flanged connections or a specific Cv flow coefficient.
200 psi maximum operating pressure
This pressure rating is the primary limit that determines if the valve matches the system design. Verify that the normal and peak pressures in the piping network stay at or below this figure before purchase. The valve carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- Brass body resists corrosion for long service life
- 200 psi rating handles typical residential water pressure
- Non-rising stem fits tight installation spaces
- Wheel handle gives clear on/off control
- Screw-in bonnet allows straightforward maintenance access
Specifications
| Brand | ZORO SELECT |
|---|---|
| Size | 1" |
| Type | Other |
Questions about this item
Does the brass gate valve ship with any extra fittings or do I need to buy pipe tape and adapters separately?
The valve has 1 in female NPT threads on both ends; pipe tape or sealant and any required adapters are not included and must be purchased separately.
How do I decide between the 200 psi water rating and the 125 psi steam rating for my system?
Use the 200 psi figure for cold or hot water lines and the 125 psi figure for saturated steam lines; do not exceed the lower limit when steam is present.
What does the 200 psi operating pressure mean once the valve is installed in a real plumbing run?
It is the maximum non-shock pressure the brass body, solid wedge and cellulose-fibre seal can hold at ambient temperature; system pressure spikes must stay below this value.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
