We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short galvanized steel pipe nipple with threaded ends

Value Brand

Value Brand 1/8" MNPT Close TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-BBKE-2QG7J

A 1/8 inch galvanised steel pipe nipple rated for 300 psi air, gas and potable water systems

  • Galvanised coating resists corrosion in wet environments
  • Schedule 40 wall handles 300 psi at 150 °F
  • Welded steel construction suits air, gas and potable water
  • Close TBE design fits tight 3/4 in runs
  • Prop 65 listed for California chemical disclosure

1/8" Schedule 40 Galvanized Steel Pipe Nipple

This close-threaded nipple connects two female NPT fittings in air, gas or potable water lines. It is made from welded steel with a galvanized coating for corrosion resistance. The fitting meets Schedule 40 dimensions for standard plumbing and industrial use.

Electric resistance welded construction

The 13/32 inch outside diameter and 3/4 inch overall length suit tight spaces where a close nipple is required. Male NPT threads on both ends allow direct engagement without additional couplings. Rated for 300 psi at 150 degrees F and 150 psi steam at 350 degrees F.

Replaces worn or corroded Schedule 40 nipples

The jump is worth it when threads are damaged, leaks appear at joints or system pressure approaches the 300 psi rating. Not suited for applications requiring longer spacing between fittings or for fluids incompatible with galvanized steel.

Highlights

  • Galvanised coating resists corrosion in wet environments
  • Schedule 40 wall handles 300 psi at 150 °F
  • Welded steel construction suits air, gas and potable water
  • Close TBE design fits tight 3/4 in runs
  • Prop 65 listed for California chemical disclosure

Specifications

BrandZORO SELECT

Questions about this item

What pressure does the 1/8" MNPT Schedule 40 nipple handle at 150°F?

It is rated for 300 psi maximum operating pressure at 150°F and 150 psi steam pressure at 350°F.

What are the thread size and overall length for fitting this nipple?

It has 1/8" MNPT threads on both ends and an overall length of 3/4 in with a 13/32 in outside diameter.

How do I seal the tapered MNPT threads without cracking the galvanized fitting?

Apply PTFE tape or pipe dope on the male threads only, hand-tighten, then turn one to two full turns with a wrench — over-tightening splits the fitting.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.