Value Brand
Value Brand 1/4" NPT Steel Nipple 2 1/2" Schedule 80
Steel pipe nipple connects air, gas, oil, or steam lines with 2000 psi rating at 150°F
- Schedule 80 steel handles 2000 psi at 150 Degrees F
- Seamless construction resists leaks under pressure
- 1/4 in NPT threads fit standard pipe sizes
- Black finish protects against corrosion in air or oil service
- 2 1/2 in overall length suits tight installations
1/4-inch NPT steel pipe nipple
This 2 1/2-inch Schedule 80 nipple is a male-threaded connector for joining two female NPT fittings in fluid-handling systems. It is built from seamless steel with a black finish and rated for air, natural gas, non-potable water, oil and steam service. The component suits maintenance, repair and original-equipment plumbing where a short, rigid spacer is required.
Schedule 80 pressure rating
The fitting withstands up to 2000 psi at 150 degrees Fahrenheit and 300 psi saturated steam at 550 degrees Fahrenheit. Its seamless construction and Schedule 80 wall thickness provide the mechanical strength demanded by high-pressure hydraulic and steam lines. Select this nipple only when the system design calls for Schedule 80 pressure capability.
Threaded integration requirements
Both ends carry 1/4-inch male NPT threads, so each connection needs a matching female NPT port such as a coupling, valve or equipment inlet. The 17/32-inch outside diameter fits standard Schedule 80 pipe dimensions, allowing the nipple to thread directly into compatible fittings without adapters. Installers must apply suitable thread sealant and verify that the mating components share the same pressure class.
Highlights
- Schedule 80 steel handles 2000 psi at 150 Degrees F
- Seamless construction resists leaks under pressure
- 1/4 in NPT threads fit standard pipe sizes
- Black finish protects against corrosion in air or oil service
- 2 1/2 in overall length suits tight installations
Specifications
| Brand | ZORO SELECT |
|---|
Questions about this item
How much pressure can this 2000 psi nipple actually handle once it's threaded into my air or steam system?
The nipple is rated for 2000 psi at 150 degrees F for air, oil, natural gas or non-potable water, and 300 psi at 550 degrees F for steam service.
The threads are 1/4 inch NPT — what does that standard limit in practice?
1/4 inch NPT threads seal by taper engagement, so the connection is limited to the nipple's 2000 psi rating and requires thread sealant for leak-free joints.
With a 17/32 inch outside diameter and 2 1/2 inch length, what clearance do I need to fit and tighten it?
You need a 17/32 inch hole for the body and enough wrench swing to turn a 2 1/2 inch long nipple; a standard 1/4 inch pipe wrench or adjustable wrench fits the hex flats.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
