We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small stainless steel socket weld union with threaded ends

Value Brand

Value Brand 1/2 in Socket Weld Union 304 Stainless Steel Class 3000

SKU CH-7Y61-R3A0R

A 1/2 inch socket weld union in 304 stainless steel rated for Class 3000 pressure service

  • 304 stainless steel resists corrosion in demanding piping systems
  • Class 3000 rating handles high-pressure fluid and gas service
  • 1/2 inch socket-weld ends enable strong permanent joints
  • Female threads on both sides simplify connection to male fittings
  • California Prop 65 warning discloses regulated chemical content

1/2 in Socket Weld Union

This 1/2 in socket weld union joins two pipes of matching size in a straight line. It is made from 304 stainless steel and rated for Class 3000 pressure service. The fitting suits installers who need a corrosion-resistant joint for water, oil or gas lines in industrial or commercial piping systems. It is not intended for flare, compression or threaded connections that require a different end preparation.

Class 3000 pressure rating

The Class 3000 designation means the union is designed to hold its seal under sustained system pressure without permanent deformation. The 304 stainless body resists scaling and chemical attack during long-term exposure to hot or aggressive fluids. Repeated thermal cycling will not loosen the socket weld if the joint is correctly fused. The fitting does not contain a gasket or O-ring that could degrade and require periodic replacement.

Socket weld installation

Installation requires a socket weld machine or qualified welder to fuse the pipe into each female socket end. The pipe must be cut square, deburred and inserted to the full socket depth before welding. Misalignment or incomplete fusion are the most common causes of leaks on this type of union. The finished weld should be inspected visually and, where code requires, by non-destructive testing before the system is pressurised.

Highlights

  • 304 stainless steel resists corrosion in demanding piping systems
  • Class 3000 rating handles high-pressure fluid and gas service
  • 1/2 inch socket-weld ends enable strong permanent joints
  • Female threads on both sides simplify connection to male fittings
  • California Prop 65 warning discloses regulated chemical content

Specifications

BrandZoro Select

Questions about this item

Does the 304 stainless steel union get hot or create noise when used continuously in a Class 3000 plumbing system?

The fitting is a passive component with no moving parts or power draw, so it generates no noise and no heat of its own during all‑day operation.

What pipe size and schedule must I already have to socket‑weld this 1/2 in union?

You need 1/2 inch nominal pipe with a schedule that matches the Class 3000 pressure rating for a proper socket weld joint.

Will the 304 stainless steel union join cleanly to older carbon‑steel pipe already in place?

Direct socket welding of 304 stainless to carbon steel is not standard practice; a transition piece or appropriate welding procedure is required.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.