Value Brand
Value Brand 1-1/2" x 100 ft Rubber Water Discharge Hose 125 PSI
A 100 ft rubber discharge hose with a 1-1/2 in inside diameter, rated for 125 psi working pressure and a 375 psi burst rating
- Handles hot water up to 180°F with SBR tube material
- 125 psi working pressure suits irrigation and dewatering tasks
- 375 psi burst rating gives a 3:1 safety margin
- Braided fiber reinforcement resists kinking and abrasion
- 100 ft continuous length reduces coupling points
1-1/2" x 100 ft Rubber Water Discharge Hose
This 100-foot rubber discharge hose has a 1-1/2 inch inside diameter and a 1-3/4 inch outside diameter. It is built with an SBR tube and a white polyester cover reinforced by a fiber braid. The hose is rated for a maximum working pressure of 125 psi at 70 degrees Fahrenheit. It suits water transfer tasks in agricultural, construction, or industrial settings.
Verify fitting size and pressure requirements
Check that your pump or outlet uses a 1-1/2 inch connection to match the hose inside diameter. Ensure the system operating pressure does not exceed 125 psi at 70 degrees Fahrenheit. The burst pressure is 375 psi with a 3:1 safety factor. Confirm the media temperature stays within the negative 22 to 180 degrees Fahrenheit range. This hose is not rated for vacuum service.
Connects to compatible couplings for bulk water
The bulk hose configuration requires separate couplings or clamps matched to the 1-3/4 inch outside diameter. The SBR tube and polyester cover resist abrasion and weather during layout. The fiber braid reinforcement handles the rated pressure while keeping the line flexible. It frees the operator from shorter lengths that need frequent joining.
Highlights
- Handles hot water up to 180°F with SBR tube material
- 125 psi working pressure suits irrigation and dewatering tasks
- 375 psi burst rating gives a 3:1 safety margin
- Braided fiber reinforcement resists kinking and abrasion
- 100 ft continuous length reduces coupling points
Specifications
| Brand | Zoro Select |
|---|
Questions about this item
Does the 100 ft hose come with fittings or do I need to buy couplings separately?
The hose is supplied as bulk hose without attached fittings; couplings or clamps must be purchased separately for the 1-1/2 in. inside diameter.
Is the 125 psi working pressure the right choice for my pump or should I look for a different rating?
Choose this hose when your pump or system operates at or below 125 psi at 70 °F; the 3:1 safety factor means the burst pressure is 375 psi.
Will the hose stay flexible in cold weather and handle hot water up to 180 °F?
The SBR tube and polyester braid are rated from -22 °F to 180 °F, so the hose remains flexible in freezing conditions and handles hot water discharge within that range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
