We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Chrome-finished brass extension trap, 12 inch slip-joint tube with nut and washer

Value Brand

Value Brand 1-1/2 in Brass Chrome Extension Trap 12 in 22 ga

SKU CH-67Q7-MVAYA

1-1/2 inch chrome brass extension trap connects kitchen sink waste tube to drain with 12 inch length and 22 gauge thickness

  • ColorSilver
  • Brass construction resists corrosion for lasting kitchen sink performance
  • 12-inch overall length connects waste tube to drain trap
  • 22-gauge wall thickness provides reliable strength for daily use
  • Chrome finish adds clean appearance and surface protection
  • Slip-joint connection with included nut and washer enables straightforward installation

Brass Chrome Extension Trap 12 in

The Value Brand extension trap connects a kitchen sink waste tube to the drain trap using a 12 inch brass tube with a chrome finish. The slip connection uses 1 1/2 inch nominal pipe size and 11.5 NPSM threads. A nut and washer are included for installation. The 22 gauge wall thickness provides standard durability for residential plumbing.

Slip Connection with Included Nut and Washer

Brass construction resists corrosion while the chrome finish matches common kitchen fixtures. The slip joint design allows the tube to slide into the trap and waste tube before tightening the supplied nut. No soldering or threading tools are required for a watertight seal. The silver colour blends with stainless steel and chrome sinks.

Verify Existing Waste Tube and Trap Sizing

Confirm that both the sink waste tube and the drain trap accept 1 1/2 inch slip connections with 11.5 NPSM threads. The 12 inch overall length must span the distance between the two fittings without stretching or compressing the joint. California Proposition 65 warnings apply to this product.

Highlights

  • Brass construction resists corrosion for lasting kitchen sink performance
  • 12-inch overall length connects waste tube to drain trap
  • 22-gauge wall thickness provides reliable strength for daily use
  • Chrome finish adds clean appearance and surface protection
  • Slip-joint connection with included nut and washer enables straightforward installation

Specifications

ColorSilver
BrandZORO SELECT

Questions about this item

What does the 1 1/2 in 11.5 NPSM thread size mean for compatibility?

The 1 1/2 in 11.5 NPSM thread matches standard kitchen sink waste tubes, allowing a slip-joint connection to the drain trap without special adapters.

Will the 12 in overall length and 22 ga wall thickness fit under a standard cabinet?

At 12 inches long with 22 ga brass walls, the extension fits typical sink-to-trap distances and slides through standard cabinet openings for straightforward alignment.

How do the included nut and washer install on the slip connection?

Slide the nut onto the pipe, seat the washer against the trap inlet, then tighten the nut by hand plus a quarter turn — overtightening cracks the slip joint.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.