We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gold-coloured wheel studs with threaded shafts and knurled heads, ten pieces

V-Project Inc

V-Project Inc Extended Wheel Studs M12x1.25 50mm Gold 10pcs

SKU CH-16C2-PG9MJ

Extended M12×1.25 wheel studs, 50 mm long, grade 10.9, gold finish, 10-piece set for Nissan, Infiniti and Subaru applications

  • ColorGold
  • Commercial/ResidentialResidential
  • Grade 10.9 steel handles high clamping loads
  • 50 mm thread length fits thick spacers or rotors
  • 3 mm knurl seats securely in stock hubs
  • M12 × 1.25 pitch matches factory wheel bolts
  • Ten studs cover both axles on most listed Nissans and Subarus

Extended M12x1.25 Wheel Studs 50mm

These gold-finished extended wheel studs replace factory bolts on a wide range of Nissan, Infiniti and Subaru models. Each stud measures 50 mm in thread length with a 14.3 mm knurl and a 10.9 grade rating. The pack contains ten pieces for front or rear fitment.

Suits bolt-pattern conversions and spacer installs

The M12x1.25 thread and 14.3 mm knurl match the listed applications from 1987 through 2016. Vehicles with a different thread pitch, a smaller knurl diameter or a lower grade requirement cannot use these studs. Shops needing a different length or quantity should source an alternative kit.

50 mm thread length decides fitment

Spacer thickness plus hub face depth must leave enough thread engagement for the lug nut. Measure the stack height on the specific corner before ordering; if the combined thickness exceeds the available thread the studs will not secure the wheel safely.

Highlights

  • Grade 10.9 steel handles high clamping loads
  • 50 mm thread length fits thick spacers or rotors
  • 3 mm knurl seats securely in stock hubs
  • M12 × 1.25 pitch matches factory wheel bolts
  • Ten studs cover both axles on most listed Nissans and Subarus

Specifications

Brandv-project
ColorGold
Commercial/ResidentialResidential

Questions about this item

How far does the 50 mm thread length protrude through the hub before the lug nut seats?

The 50 mm thread length provides 50 mm of engagement beyond the hub face, allowing thicker spacers or aftermarket wheels while keeping full nut contact.

Will the 14.3 mm knurl seat fully in factory hubs without extra drilling?

The 14.3 mm knurl matches the stock wheel-stud hole on the listed Nissan, Infiniti and Subaru models, so no reaming is needed.

Which lug-nut thread pitch must I already have to use these M12×1.25 studs?

You need lug nuts with an M12×1.25 thread pitch; the studs are grade 10.9 and accept standard conical or ball-seat nuts of that pitch.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.