We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten gold wheel studs with knurled shanks and threaded ends

V-Project Inc

V-Project Inc 63mm Extended Wheel Stud M12x1.5 10pcs Gold Prelude 1985-2001 accessories - wheel

SKU CH-CCNT-ED0JA

Gold M12x1.5 extended wheel studs, 63 mm thread length, 12.20 mm knurl, grade 10.9, fit Honda Prelude 1985-2001 front and rear, ten pieces

  • ColorGold
  • Extended thread length for spacer clearance
  • 63 mm shank fits 1985-2001 Prelude front and rear
  • Grade 10.9 steel handles high clamping loads
  • 20 mm knurl matches factory hub bore
  • Ten gold-finished studs replace all corners

Honda/Acura M12x1.5 Wheel Studs 10-pack

This pack contains ten new gold-coloured extended wheel studs with a M12x1.5 thread pitch. Each stud measures 63 mm in thread length and features a 12.20 mm knurl diameter rated to grade 10.9 strength. They are designed as direct-fit pin bolts for front and rear hubs.

Fits 1985-2001 Prelude and many Honda/Acura models

The studs suit owners of a 1985-2001 Honda Prelude plus a wide range of Honda and Acura vehicles built between 1990 and 2017 including Accord Civic CR-V Integra TL TSX MDX and NSX. Buyers needing a different thread size knurl diameter or shorter stud length should look elsewhere.

63 mm thread length decides fitment

The single specification that determines compatibility is the 63 mm thread shank length combined with the 12.20 mm knurl. Verify your hub requires exactly these dimensions before ordering because the studs will not seat correctly if the knurl or thread length differs.

Highlights

  • Extended thread length for spacer clearance
  • 63 mm shank fits 1985-2001 Prelude front and rear
  • Grade 10.9 steel handles high clamping loads
  • 20 mm knurl matches factory hub bore
  • Ten gold-finished studs replace all corners

Specifications

Brandv-project
ColorGold

Questions about this item

Will the 12.20 mm knurl on these M12x1.5 studs fit my Honda Prelude hub without reaming?

The knurl measures 12.20 mm (0.480 inch) and is designed for the Prelude 1985-2001 front and rear hubs; press them in with a stud installer rather than hammering to avoid damaging the splines.

What is the correct way to install the 63 mm thread-length studs so they seat fully?

Remove the old studs, align the new 10.9-grade pin bolts in the hub holes, and press each one until the knurl shoulders seat flush — do not use lug nuts to pull them through or the threads can stretch.

When should I replace these gold 10.9-grade extended studs after track use?

Inspect the 63 mm threads and 12.20 mm knurl at every wheel change; replace any stud showing thread deformation, knurl wear, or corrosion to maintain proper clamp load.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.