We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten-foot spool of 16 AWG red and black parallel silicone wire

usbroway

usbroway 16 AWG 2 Conductor Silicone Wire 10ft Red Black 600V 200°C

SKU CH-XS3H-40ZGD

A 10 ft, 16 AWG two-conductor silicone cable rated 600 V and 200 °C for LED strips and DC hookups

  • Connector Typetype
  • Ultra-flexible silicone insulation simplifies routing in tight spaces
  • 252 strands of 0.08 mm tinned copper per conductor lower resistance and heat
  • Rated 600 V and 200 °C for demanding high-temperature environments
  • Remains pliable down to -60 °C for reliable cold-weather operation
  • 10 ft parallel red-black pair separates easily for quick DC hookups

16 AWG Silicone Wire for LED Strips

This 10 foot spool of 16 gauge parallel silicone wire is built for single colour LED strip extensions and low voltage DC hookups. Two colour coded conductors in red and black make polarity identification straightforward for hobbyists and installers.

Installation Notes

The parallel construction separates easily by hand so you can strip each conductor without special tools. Tinned copper strands resist oxidation during soldering but the soft silicone insulation can stretch if pulled too hard so support the wire near the joint.

Compatibility Check

Verify that your circuit operates at or below 600 volts and within the minus 60 to 200 degree Celsius range. Ensure the 16 gauge cross section can carry the required current for your LED strips or DC devices without excessive voltage drop.

Highlights

  • Ultra-flexible silicone insulation simplifies routing in tight spaces
  • 252 strands of 0.08 mm tinned copper per conductor lower resistance and heat
  • Rated 600 V and 200 °C for demanding high-temperature environments
  • Remains pliable down to -60 °C for reliable cold-weather operation
  • 10 ft parallel red-black pair separates easily for quick DC hookups

Specifications

Connector Typetype

Questions about this item

How can I confirm the 16 AWG silicone wire is performing correctly after installation?

Check that the connected LED strip or DC device operates without flickering and that the wire stays cool during use, confirming the 252 strands of 0.08 mm tinned copper per conductor are delivering low-resistance power.

What length and gauge of wire are included, and are connectors supplied?

The package includes a 10 ft spool of 16 AWG red-black parallel silicone wire; no connectors or terminals are included, so you will need suitable crimp terminals or solder joints for your application.

Which gauge should I choose for a single-colour LED strip extension?

For typical single-colour LED strip runs the 16 AWG version with 252 strands per conductor handles the current with minimal voltage drop; select a thicker gauge such as 14 or 12 AWG only for longer runs or higher-power loads.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.