US Cargo Control
US Cargo Control GVEB34X8 Eye Bolt 3/4 in 8 in Shank Steel
A steel eye bolt with a three-quarter inch inner diameter and eight-inch shank for secure lifting and rigging points
- TypeScrews & Bolts
- 3/4 inch eye diameter provides secure attachment point
- 8 inch shank length enables deep engagement in thick material
- Steel construction delivers high tensile strength for heavy loads
- New condition ensures full rated capacity without wear
- California Proposition 65 warning discloses regulated chemical presence
Hardware eye bolt for lifting and rigging
The US Cargo Control GVEB34X8 is a forged steel eye bolt with a 3/4 inch internal diameter and an 8 inch shank. It is designed for straight-line lifting and permanent rigging points in industrial, automotive and marine environments. The component meets the mechanical requirements for general-purpose hardware installations.
Replaces worn or undersized anchor points
Swap out corroded, bent or smaller-diameter eye bolts when the existing hardware no longer matches the load path or thread engagement required by the job. The longer shank provides deeper thread engagement in thick structural members, making the change worthwhile when the original fastener bottomed out or pulled loose. The item carries a California Proposition 65 notice for a listed chemical.
Fits tapped holes and through-bolt setups
The bolt threads into a matching 3/4 inch internal thread or passes through a drilled hole secured with a nut and washer. Its steel construction resists deformation under tension, freeing the installer from frequent replacement cycles. No specialised tools beyond standard wrenches or sockets are required for installation.
Highlights
- 3/4 inch eye diameter provides secure attachment point
- 8 inch shank length enables deep engagement in thick material
- Steel construction delivers high tensile strength for heavy loads
- New condition ensures full rated capacity without wear
- California Proposition 65 warning discloses regulated chemical presence
Specifications
| Brand | US CARGO CONTROL |
|---|---|
| Type | Screws & Bolts |
Questions about this item
What thread size and shank length does the GVEB34X8 eye bolt have?
The eye bolt uses a 3/4 in thread with an 8 in shank, so the mounting hole must accept that diameter and depth.
How do you install this eye bolt and what step is often missed?
Thread the bolt fully into a matching 3/4 in tapped hole until the shoulder seats, then tighten to the rated torque; the step many skip is confirming full shoulder contact before loading.
What maintenance or replacement should be planned for this steel eye bolt?
Inspect the threads, shank and eye for corrosion, deformation or wear before each use and replace the bolt if any damage is found.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
