US Cargo Control
US Cargo Control FH2141 1" Lashing Ring Weld On 47000 lbs
A forged weld-on lashing ring rated at 47,000 lbs for heavy-duty tie-down points
- Weld-on forged ring handles 47,000 lbs loads
- One-inch diameter suits standard tie-down hardware
- Forged construction resists deformation under heavy stress
- Manufacturer-direct item ships free on $75 orders
- California Prop 65 notice included for compliance awareness
1" Forged Lashing Ring
This US Cargo Control FH2141 is a 1 inch forged lashing ring designed for permanent weld-on installation. It provides a fixed anchor point rated at 47000 lbs for heavy-duty lifting, pulling and conveying tasks. The component is supplied new and ships directly from the manufacturer.
Heavy-duty tie-down anchor
It suits operators who need a high-strength welded attachment for securing extreme loads on trailers, equipment or structural steel. Buyers requiring a bolt-on, removable or lower-capacity ring should look at alternative mounting styles or ratings.
47000 lb capacity headroom
The ring comfortably handles tie-down and lifting duties up to its 47000 lb working load limit in straight-pull configurations. It runs out of margin when loads exceed that rating or when side-loading angles reduce effective strength beyond the design envelope.
Highlights
- Weld-on forged ring handles 47,000 lbs loads
- One-inch diameter suits standard tie-down hardware
- Forged construction resists deformation under heavy stress
- Manufacturer-direct item ships free on $75 orders
- California Prop 65 notice included for compliance awareness
Specifications
| Brand | US CARGO CONTROL |
|---|
Questions about this item
What welding equipment is required to attach the FH2141 lashing ring?
The ring is a weld-on forged mounting ring, so it must be welded directly to a steel structure using appropriate welding equipment and techniques for the base material.
Will the 47000 lbs capacity ring work with my existing 1 inch tie-down straps?
Yes, the 1 inch lashing ring is sized to accept standard 1 inch webbing and hardware, allowing it to integrate with existing tie-down straps of that width.
How can I verify the ring is properly installed after welding?
Inspect the welds for full penetration and absence of cracks, confirm the ring sits flush against the mounting surface, and test under a controlled load before full service.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
