We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two-piece plastic shell with sun-and-moon print, rubber feet, precise cut-outs

Universal

Universal A2337 2 in 1 Accessory for MacBook Air 13.3 inch 2018-2021

SKU CH-0FF6-A19VF MPN A2337

A two-piece plastic shell with rubber feet that protects compatible MacBook Air 13.3 inch models from 2018 to 2021 while keeping ports and vents accessible

  • Compatible with MacBook Air 13.3 inch models A2337 M1 A2179 A1932
  • Two-piece ultra-thin shell keeps laptop light and easy to remove
  • Four rubber feet hold device firmly in place during use
  • Fully vented design allows safe heat release while protecting
  • High-definition inkjet print resists fading and hides fingerprints

Compatible MacBook Air models

This accessory fits MacBook Air 13.3 inch models from 2018 to 2021 including A2337, A2179 and A1932. The two-piece shell also covers earlier 13.3 inch variants such as A1466 and A1369. Buyers must verify the Axxxx number on the base before ordering because the case is not universal across all Apple laptops.

Heat dissipation and stability

Fully vented cut-outs allow the laptop to release heat naturally during normal use. Four rubber feet on the bottom keep the device firmly in place on a desk. The slim plastic shell adds minimal bulk while maintaining access to all ports and controls.

Sustained use protection

The hard-shell construction resists scratches and daily wear over long periods. High-definition inkjet printing on the cover retains colour brightness without fading. The non-slip texture continues to hide fingerprints even after extended handling.

Highlights

  • Compatible with MacBook Air 13.3 inch models A2337 M1 A2179 A1932
  • Two-piece ultra-thin shell keeps laptop light and easy to remove
  • Four rubber feet hold device firmly in place during use
  • Fully vented design allows safe heat release while protecting
  • High-definition inkjet print resists fading and hides fingerprints

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the two-piece plastic shell on my MacBook Air 13.3 A2337 without trapping the rubber feet?

Align the top and bottom halves with the laptop closed, press each corner until the four rubber feet seat flush, then open the lid to confirm the vent cut-outs sit clear of the hinge.

What part of the case will need replacing first if the printed design starts to wear off?

The high-definition inkjet print on the outer shell fades before the plastic cracks, so the whole two-piece cover is the replacement item.

At what point does heat build-up become noticeable during sustained loads with the fully vented shell fitted?

The vents follow the MacBook Air 13.3 factory exhaust pattern, so thermal limits match the laptop's own throttling point rather than the case restricting airflow.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.