Unity Rear Complete Strut Assembly Kit 2-15120-001

Unity Rear Strut Kit for Neon 1995-1999

This Unity rear complete strut assembly kit is built for 1995-1999 Dodge Neon and Plymouth Neon models. It arrives as a pair of fully assembled units, each containing an OE-style strut, top mount, bearing plate, bumper, insulators and coil spring. The design targets DIY owners and shops wanting a direct bolt-in repair without compressing springs or sourcing separate components.

Pre-assembled units remove spring-compression steps

Because every strut ships pre-assembled, the installer avoids the high-force spring compression that normally demands specialty tools and safety precautions. The kit replaces the entire corner in one motion, so alignment angles return to factory specs faster than a piece-by-piece rebuild. Long-term, the all-new components resist the sag and noise that develop when only the cartridge is swapped on an old housing.

Bolts in with standard hand tools

Installation follows the factory service procedure: remove the wheel, unbolt the old assembly at the knuckle and top mount, then fasten the new unit to the same points. Torque values come from the vehicle manual, not the kit. The most common issue is reusing corroded lower bolts or forgetting to torque the upper mount nuts to spec, which can cause clunking after the first few miles.