Unity Front Complete Strut Assembly Kit 2013-2015 Ford Escape

Complete Strut Kit for 2013-2015 Ford Escape

This Unity kit provides two fully assembled front strut assemblies designed specifically for the 2013-2015 Ford Escape. Each unit arrives preassembled with the coil spring, top mount, bearing plate, bumper, and insulators already installed. The kit targets DIY owners and shops that want to restore ride quality without the hassle of compressing springs or sourcing individual components. Buyers who need rear suspension parts or coverage for other model years will not find them in this package.

Replaces Worn Original Front Struts

The assemblies directly replace the factory front struts on the listed Escape models, addressing leaks, noise, or collapsed damping that develop over time. Because every component is new, the repair eliminates the labour and specialty tools normally required to swap springs onto old housings. The jump is worth it when the original units show fluid loss, excessive bounce, or uneven tyre wear that signals the end of their service life. Vehicles with modified ride height or non-standard spring rates are not covered by this kit.

Bolt-On Installation Frees Up Shop Time

Each strut bolts into the existing mounting points using the vehicle's original hardware, so no additional brackets or adapters are needed. The preassembled design removes the need for a spring compressor, freeing up the tool for other jobs and reducing the time the vehicle spends on the lift. Installers should verify that the steering knuckle, sway-bar links, and alignment specs are within factory tolerances before fitting the new units. Builders working on all-wheel-drive variants or models outside the 2013-2015 range must confirm fitment separately.