Unity 2-15386-001 Rear Complete Strut Assembly Kit 1996-1998 Chrysler Sebring Convertible

Direct-fit suspension kit

The Unity 2-15386-001 rear complete strut assembly kit is built for 1996-1998 Chrysler Sebring Convertible models only. Two fully assembled struts arrive with coil springs, top mounts, bearing plates, bumpers and insulators pre-installed. This eliminates the need for specialty spring compressors and reduces installation time. The kit restores factory ride height and handling without mixing old and new components.

Consistent damping over distance

Each strut uses new internal valves and fresh hydraulic fluid matched to the supplied coil spring rate. Because every part is new, damping force stays uniform through repeated compression and rebound cycles on rough roads. The assembly avoids the fade that occurs when worn seals or contaminated fluid degrade performance during extended trips. Ride quality remains predictable from the first mile to the last.

Sealed operation with no maintenance

The cartridge design keeps fluid and gas isolated from road spray, salt and debris. No external reservoirs or adjustable fittings are present, so there are no leak paths to monitor. Power draw is not applicable to this passive suspension component. Noise contribution is limited to normal tyre and bush interaction, with no pump or compressor activity.