Unity 2-11130-001 Front Complete Strut Assembly Kit

Front Strut Kit for 1998-2011 GM W-Bodies

This Unity 2-11130-001 kit supplies two fully assembled front strut units for 1998-2002 Oldsmobile Intrigue and 2000-2011 Chevrolet Impala models, including police and taxi variants. Each unit arrives with the strut, top mount, bearing plate, bumper, insulators and coil spring already combined. The pre-assembled design removes the need for a spring compressor or other specialty tools during installation. It is intended for DIYers and shops that want a complete, bolt-on repair.

Ready-to-install units with no spring compression

Because the coil spring, mount, bearing, bumper and insulators are factory-assembled, the job avoids the high forces and noise of compressing a spring on the bench. No special equipment is required, so the work stays quiet and draws only ordinary hand-tool effort. The assemblies use all-new components built to match original equipment dimensions, delivering reliable damping and ride height from the first drive. Installation time is reduced compared with piece-by-piece rebuilds.

Bolts to existing steering knuckle and strut tower

Each strut mounts to the original steering knuckle and upper strut tower points on the listed W-body vehicles, reusing the factory fasteners and alignment settings. The kit includes both left and right units, so the front axle is refreshed in a single session without hunting for separate parts. No additional brackets, spacers or modified hardware are needed. Buyers who need rear suspension components or applications outside the 1998-2011 fitment range must source those separately.